Replacement Air Distribution Box for Furrion Chill HE RV Air Conditioners

Question

Question:

I have Furrion Chill HE 13.5k roof unit. FACR13HESA-PS-AM What do I need for the inside to get it working? Just an air distribution box? It will be ductless. I just have the roof top unit. Thanks in advance………….

asked by: Eric

0

Expert Reply:

You are going to need the Replacement Air Distribution Box for Furrion Chill HE RV Air Conditioners item # FR28PR to install on the inside of your trailer. This will get your Furrion Chill HE Replacement RV Air Conditioner Unit item # FR26PR up and running.

expert reply by: Jerred H

0

Answer 1

An E3 error code on a Furrion AC system means you have a communication error between the controller and thermostat. This is typically caused by the A and B wires being flipped from the factory. With your trailer being so new this could be the cause…

view full answer...

Answer 2

Dip 4 will need to be placed in the "on" position in order for the signal to pass from the controller in your Furrion Chill HE Replacement RV Air Conditioner #FR58PR to the furnace. On the single zone controllers the first two dip switches…

view full answer...

Answer 3

The only real differences between the Furrion Chill Premium RV Air Conditioner System #FR26PR and the Furrion Chill HE RV Air Conditioner System #FR58PR is the BTU rating, other than that they are the exact same. For your 2021 Heartland Fuel 265 I…

view full answer...

Answer 4

Yes, the Furrion manual air distribution box part #FR28PR does come with a controller if that is what you are asking about. It also has controls built into it in case that is what you asked about. It is the same as what you see in the pictures.

view full answer...

Answer 5

I have a solution for you, see it listed below: **Replacement Air Distribution Box for Furrion Chill RV Air Conditioner - Electric Control - White #FACT11MA-PS. You can bypass your wall thermostat and use one of these units for sure.

view full answer...

Answer 6

An E3 error code for a Furrion AC unit indicates a communication error between the thermostat and controller so the typical cause is usually a cut or bend in the wiring causing a break. Since you've stated you tried directly connecting the…

view full answer...

Answer 7

Hey Mark, thanks for reaching out! Attached are 2 photos that Furrion provides in their instructions for the wiring of the Furrion Chill HE RV Air Conditioner System - Mutli Zone #FR67FJ. I believe the wire you're referring to is the…

view full answer...

Answer 8

Yes, you can use the Replacement Premium Wall Thermostat for Furrion Chill HE RV Air Conditioner - Multi Zone #FR93PR with a single air conditioner. However, unless you plan to add an extra down the line you might as well save some money and use the…

view full answer...

Answer 9

This is actually the correct installation of a Furrion #FR86SR when you've got a furnace with two wires, so you've installed this correctly and will be ready to go when the cold weather strikes. Additionally, what you're experiencing with…

view full answer...

Answer 10

The thermostat for the Advent Air RV Air Conditioner System #ADV44FR is powered from the controller inside the air distribution box. You would only need to have 12v power ran up to the controller to power the thermostat.

view full answer...

Answer 11

That is a great question! I reached out to my contact at Furrion and the wires of the Replacement Single Zone Controller for Furrion Chill RV Air Conditioner Setup #FACC12SA-BL have a few different bundles. The first bundle has 6 wires in it and is…

view full answer...

Answer 12

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Replacement Air Distribution Box for Furrion Chill HE RV Air Conditioners

Product Page this Question was Asked From

Continue Researching