Hinge that Can be Used on Legend Trailer Ramp

Question

Question:

I would like to know if you have a hinge you could recommend? I have a Legend aluminum trailer that has a 2 piece ramp. It hauls a Honda Talon side by side of a golf cart. the tube is 1.5X1.5x1/8 thick. I can modify the width if need be. Thank you

asked by: Kevin V

0

Expert Reply:

The Polar hinge part # PLR1902 would be a great option. This is a heavier duty hinge that would easily do the job.

expert reply by: Jameson C

0

Answer 1

Hello Alan, While we don't have a database to figure out the exact hinge you need, we can try to track down the part you're looking for. Does it look similar to these? -Ramp Door Hinge - 8-3/16" Long - 1" Pin Diameter Steel #PLR1902…

view full answer...

Answer 2

It sounds like your assemblies are not the typical assemblies and will need to be replaced. For your brake assemblies, I recommend the Electric Trailer Brake Kit - Self-Adjusting #AKEBRK-7-SA along with mounting hardware #BRKH12. If you don't…

view full answer...

Answer 3

It is not recommend to jack up a trailer by the axle. This may cause damage to the axle itself. It also puts too much stress on the leaf springs. Instead, you will want to place the jack under part of the trailer frame preferably next to the leaf…

view full answer...

Answer 4

The Ramp Door Hinge #PLR1902 does require welding of both portions. The tab gets welded as you stated to one side and the outside cylinders get welded to the opposite side. I've attached a couple pictures to assist.

view full answer...

Answer 5

Appreciate the photo, and while I couldn't find any reference to part number I550-000, we do have a possible option for the ramp door hinge: - Ramp Door Hinge #PLR1902 The #PLR1902 has a pin that measures 8-3/16" long x 1" diameter and…

view full answer...

Answer 6

Good afternoon George; no it usually does not! The Fill-Rite Piston Fluid Pump #FR53XQ uses a hand lever with a double piston design and moves 20 gallons per 100 strokes, which means fewer cycles to move the same fuel compared to the rotary crank…

view full answer...

Answer 7

According to Blue Ox, it'll take an experienced installer about 4 to 5 hours to complete the installation of their #BX1128 Base Plate Kit on a 2016 Jeep Grand Cherokee. The install isn't what I'd call super-difficult, but the installation…

view full answer...

Answer 8

Hey Michael, 3/4 inch diameter spindles are basically unheard of nowadays so you won't be able to find one. The 1 inch diameter of the 1-1/16 inch diameter spindles are the current size that is most likely seen. You'd need to know the…

view full answer...

Answer 9

Hey Carlos, the closest option we have would be the Tandem Axle Jeep Style Trailer Fenders part #HP62VR which is 72 inches long and 10 inches wide. It is also diamond plate like you wanted but it is not painted.

view full answer...

Answer 10

If you have a pole tongue trailer you will need to use a pole tongue adapter like the #RP58393 to use a weight distribution system. The Husky part #HT32218 is not compatible with this adapter and Husky does not offer an adapter so you would need to…

view full answer...

Hinge that Can be Used on Legend Trailer Ramp

Product Page this Question was Asked From

Continue Researching