Charger to Use on Battery of Trailer that Can Connect to Generator or Shore Power

Question

Question:

I have a 16foot cargo trailer. Trying to add a powered vent fan and a battery to run everything off of. I thunk I want tonjust do a separate system to avoid running truck battery dead. So I would want to be able to plug in to either shore power or a generator to keep battery full. Do u have any recommendations for controller/charger to make this happen

asked by: Andrew R

0

Expert Reply:

You could use a battery charger like the NOCO charger part # 329-GENIUS10 with the generator or shore power like you mentioned to keep the battery charged.

expert reply by: Jameson C

0

Answer 1

You should have no problem setting this battery charger and leaving it for months on end, unattended. The NOCO Battery Chargers work very differently than the old, traditional battery tenders. The old tenders used a trickle charge. Basically they…

view full answer...

Answer 2

Hey Eric, to get the best charge on your batteries I would go with a 2 battery bank NOCO 10 amp charger part #NOC34FR.

view full answer...

Answer 3

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 4

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 5

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 6

Hey Andrew! Yes, Furrion does have a Chill Cube model with a heat pump. This was actually just released for aftermarket sale. You will need a complete system to make the switch, new R32 units aren't backwards compatible with old R410A systems.…

view full answer...

Answer 7

Hi David! There are quite a few hitches offered for your 2026 Honda Odyssey, so I definitely understand wanting to know the differences. There are basically three styles available for you and I have them broken out below: Exposed Crosstube: etrailer…

view full answer...

Answer 8

The main difference between the Curt Trailer Hitch Receiver part #C13416 and the EcoHitch Hidden Trailer Hitch Receiver part #EH97FR is that the EcoHitch has a completely hidden cross tube whereas the Curt cross tube will be visible from the rear of…

view full answer...

Answer 9

The Hollywood Racks Trail Rider 2-Bike Rack #HR200 weighs about 35 lbs. The Swagman XC 2-Bike Rack #S64650 is lighter at about 26 lbs. The biggest difference between the two is the Swagman rack is rated for 2 bikes at 35 lbs each and the Hollywood…

view full answer...

Answer 10

The Swagman XTC4 4-Bike Rack #S64665 and Hollywood Racks Destination 4-Bike Rack #HR4000 are two of the best values in regards to 4-bike racks, and when taking everything into consideration I highly recommend the Destination #HR4000. There are a…

view full answer...

Answer 11

Hey Gregory, thanks for reaching out. Yes the Curt #C13195 hitch is exactly what you'll need for carrying a few bikes on the back of your 2020 Hyundai Santa Fe. it has a 2" receiver and 750 lb tongue weight capacity so 4 bikes will not be a…

view full answer...

Answer 12

Hey Chris! The Hollywood Racks CrossTrack Bike Rack part #HLY98RR already comes with a hitch lock so no need to get one separately! There is also an integrated cable lock to wrap around your bikes as well. The CrossTrack is expandable so that you can…

view full answer...

Charger to Use on Battery of Trailer that Can Connect to Generator or Shore Power

Product Page this Question was Asked From

Continue Researching