Grommet and Wiring to Install 6 Diode Optronics LED Trailer Tail Light for Stop, Turn, and Tail
Published 08/25/2023
Products Featured in This Question
Question:
What rubber insert and wiring can I use to install this light?
asked by: Greg J
0
Expert Reply:
To install the Optronics LED Trailer Tail Light # STL12RCB you need the Grommet # a70gb and one of the following wiring pigtails:
- Straight # A45PB
- Right Angle # A47PB
Attached is an installation video for you to check out!
expert reply by:
Jon G
0
Product Page this Question was Asked From
Optronics LED Trailer Tail Light - Stop, Turn, Tail - Submersible - 6 Diodes - Oval - Clear Lens
- Trailer Lights
- Tail Lights
- Brake/Tail/Turn
- Oval
- Recessed Mount
- Submersible Lights
- LED Light
- 6-1/2L x 2-1/4W Inch
- Red
- Optronics
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Q&A: Will Replacement Center Cap for 16" Aluminum Viking Series Wheels Fit Other 16" Wheels
- Q&A: Replacement Propane Gas Detector for an Atwood 31013 Propane Detector
- Article: Most Popular Wheel Bearings
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Trailer Wiring Diagrams
- Q&A: Torque Specification for Lugs Nuts on 5/8-Inch Stud on Dexter Hub
- Q&A: Recommended Replacement Converter for a Elixir ELX-45
- Q&A: Fifth Wheel Hitch to Gooseneck Adapter Compatible with Lippert Rota Flex Pin Box
- Q&A: Difference Between Dexstar and Taskmaster Steel Modular Trailer Wheel 16 inch Diameter 6 inch Wide
- Q&A: How To Mount A Breakaway Switch When The Baseplate Doesn't Have A Mounting Point
- Article: Best Ladder Racks
- Article: Trailer Tire Sizing
- Article: Wiring Trailer Lights with a 5-Way Plug (It's Easier Than You Think)