Can Model 10 Actuator Be Used for Drum and Disc Brakes  

Yes, the Dexter Zinc-Plated Brake Actuator w/ Drop, Electric Lockout #T4750620 is compatible with disc brakes.

Yes, you can swap out the master cylinder of your Titan model 10 actuator to the part #T4749501042 that you referenced so that it would operate a set of disc trailer brakes.

The problem with using a drum brake actuator with disc brakes is that it's not going to supply enough pressure to fully engage the assemblies. Drum brake actuators typically put out around 1,000 to 1,200 psi (sufficient for drum brake assemblies)…

The Dexter DX7.5 Drop-N-Go Brake Actuator #099-175-20 should be wired to the reverse light circuit on your 7-way. Although I do not have a specific wiring diagram, this is a simple process. There are two wires on your brake actuator. One will be the…

What a lockout on a hydraulic brake coupler does is prevent the brakes from applying when you back the trailer. An electric lock out is tied into the reverse lamp circuit on the vehicle so that when the vehicle is shifted into reverse the solenoid in…

Since you have a wheelbase/axle spacing of 38 inches the correct hanger kit for slipper springs would be the part #HAP-105-205-01. And then for a 7k trailer axle the u-bolt kit you'd want would be the part #APUBR-8. I attached the diagram to use…

I did some checking and the hub/drum we offer that will work for you is the part #8-430-5UC3. This uses the same bearings as the 8-415 and will be an exact fit aside from the fact this is a non-ABS setup and the 8-415 came in an ABS setup and non-ABS…

The manual lockout on your Atwood 85778 surge brake coupler is there so that you can back up the trailer without the brakes locking up on you. Yes you can safely tow your trailer with the broken manual lockout, you just have to make sure you…

On a 2005 Chevy Silverado 1500, If you are facing the front of the truck looking at the power distribution box, there will be a post at the back left side and a fuse slot near it. It is that fuse slot that you will install a 30 amp fuse. I have…

The 40 amp fuse for your 2006 Chevrolet Silverado tow package is used for the 12 volt battery charge circuit. This fuse is located toward the front of the underhood fuse box closest to the front auxiliary positive post (see photo). There may be a…

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

If your current springs have 5 leaves then going to a 7 leaf spring will increase the height of the trailer a little and make the trailer more susceptible to sway. Regarding capacity if you go with springs rated higher than what is required it will…