Installation Instructions For The JR Products RV Cabinet Door Struts # 37270545

Question

Question:

how do i know what size to use how do i measure my cabinet door

asked by: Jim

0

Expert Reply:

The RV Cabinet Door Struts # 37270545 has installation instructions included with it that I've also attached a picture of below.

expert reply by: Kevin C

0

37270545 Installation Instructions
(click to enlarge)

Answer 1

Yes, the RV Cabinet Door Struts #37270555 will work horizontally on your bathroom cabinet doors.

view full answer...

Answer 2

The RV Cabinet Door Struts #37270555 that you mentioned is designed to install to a ball socket like #3691858. However, these cabinet door struts do include the necessary ball socket needed for installation.

view full answer...

Answer 3

Yes, the RV Cabinet Door Struts #37270555 that you referenced can be used on vertical cabinets that are only 6 inches tall. It would just be a matter of placing where to mount the strut for it to make sense. You might have to mount on back wall of…

view full answer...

Answer 4

There is no specified weight limit for the RV cabinet hinge #37270555. Generally they will work with any size cabinet door found in an RV or camper. We have seen them used on doors wider than 2', and you can use 2 struts per door for larger doors…

view full answer...

Answer 5

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 6

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 7

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 8

According to Blue Ox, it'll take an experienced installer about 4 to 5 hours to complete the installation of their #BX1128 Base Plate Kit on a 2016 Jeep Grand Cherokee. The install isn't what I'd call super-difficult, but the installation…

view full answer...

Answer 9

Hi Paul, you’re definitely on the right track here, and I can help you narrow this down with confidence. With your tandem 3,500 lb Dexter axles and 33 inch spacing, both the Dexter EZ Flex part #K71-652-00 and the Lippert Road Armor part #LC53CK are…

view full answer...

Answer 10

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Answer 11

The #84 spindle is just a common way to identify the spindle dimensions typically used for 3,500 lb axles. So instead of listing out the parts, people can just say they have #84 spindles and it's easier to know what fits it. The CE Smith Trailer…

view full answer...

Answer 12

Even though I cannot comment specifically on the grease you used because I am not familiar with it, I can tell you the best grease for trailer bearings is a a grease with a rating of GC-LB, which just means it is made to withstand very high…

view full answer...

Installation Instructions For The JR Products RV Cabinet Door Struts # 37270545

Product Page this Question was Asked From

Continue Researching