Is The Pad For The Replacement 22-1/2" Legs For The Ground Control 3.0 Welded Or Pinned In Place
Question:
2021 260RD, I have 4 point Lippert 3.0 levelers. The levelers behind rear tore are 24 inch. This makes my depature angle bad and gives me aboit 4 inches clearance from ground to bottom of foot pad. I want to replace with 22 inch leveler to give more clearance. My question: Does the 22 inch come with foot pad attached by pin and not welded? If so part info please. I am concerned using welded foot pad on 4 point system. thanks
asked by: John K
Expert Reply:
The foot pad of the Replacement 22-1/2" Right Rear Leg for Lippert Ground Control 3.0 Electric Leveling System # LC428493 is welded to inner tube to jack to help shorter the total height for more clearance. The original model has the inner tube a bit longer to allow for room for a pin and clip. Unfortunately there currently isn't a shorter model with a pin & clip design.
In the attached video below Dave will go over this starting at the 2:20 minute mark.
Product Page this Question was Asked From
Replacement 22-1/2" Right Rear Leg for Lippert Ground Control 3.0 Electric Leveling System
- Accessories and Parts
- Camper Jacks
- Trailer Jack
- Legs
- Follow Leg
- Lippert
more information >
Continue Researching
- Shop: Lippert Ground Control 3.0 Electric 5th Wheel RV Leveling System w Touchpad - 4-Point Set
- Shop: Lippert Ground Control 3.0 Electric 5th Wheel RV Leveling System w Bluetooth Control - 6-Point Set
- Shop: Replacement 22-1/2" Left Rear Leg for Lippert Ground Control 3.0 Electric Leveling System
- Shop: Replacement 22-1/2" Right Rear Leg for Lippert Ground Control 3.0 Electric Leveling System
- Video: Lippert Ground Control Replacement Leg Installation - 2015 Forest River Vengeance TT Toy Hauler
- Video: All About the Replacement 24-1/2" Left Rear Leg
- Q&A: Replacement Wiring Harness and Right Rear Jack for Lippert Ground Control 4 Point System
- Shop: Replacement Control Module for Lippert Ground Control 3.0 Electric Leveling System
- Q&A: Shorter Rear Jack Legs for Lippert Ground Control System to Help with Ground Clearance
- Q&A: Replacement Short Rear Legs for Lippert Ground Control 3.0
- Q&A: Can You Purchase the Shorter 22.5 Inch Rear Legs with the Lippert Ground Control System 3.0?
- Q&A: Shorter Replacement Rear Jacks For Lippert Ground Control 3.0 4-Point Leveling Increased Clearance
- Shop: RV Jack Pads
- Shop: Correct Track Trailer Alignment and Lift Kit - Tandem Axle
- Video: Ultimate Overview of the Replacement I-Beam Jack Bracket for Lippert Ground Control 3.0
- Shop: Replacement 24-1/2" Right Rear Leg - Lippert Ground Control 3.0 Electric Leveling System
- Q&A: Replacement Jack For A Lippert Hydraulic Leveling System
- Q&A: What are the Shortest Legs Available for the Lippert Ground Control 3.0 Electric Leveling System?
- Search Results: snappad rv jack pads
- Search Results: lippert leveling jacks
- Search Results: lippert camper jacks
- Video: Review of Lippert Replacement Ground Control 3.0 Electric Leveling System Control Module - LC304136
- Video: All About the Replacement Pad for SnapPad Jack Stand Pad System
- Video: Lippert Components Trailer Jack LC342610 Review
- Video: Lippert Ground Control 3.0 Electric 5th Wheel RV Leveling System Review
- Search Results: lippert ground control
- Search Results: lippert landing gear
- Search Results: lippert components
- Search Results: lc358590
- Article: How to Accurately Measure Trailer Leaf Springs