Installing the Wiring on Lippert Power Stabilizer Jack
Updated 06/24/2025 | Published 11/15/2017
Question:
I got my Lippert Components Power Stabilizer Trailer Jack today but there was no wiring diagram can you help thanks
asked by: [email protected]
Expert Reply:
For your Lippert Components Power Stabilizer Trailer Jack # LC298707 the wiring is pretty simple. There are two wires that come out of the motor and they are both used as power or ground depending on the direction you want to turn the motor. To connect them to a switch, you will have power and ground to the switch and then extend or retract on the switch. Simply attach the two motor wires to the switch and reverse them if they are working the opposite way as labeled. I've attached the owners manual to assist. I've also attached the wiring diagram from Lippert to assist.
Featured Help Information
Miscellaneous Media
Continue Researching
- Shop: Replacement Double Tap Lighting Cupholder with White Light Ring for Thomas Payne RV Couches
- Shop: Replacement Cup Holder for Thomas Payne RV Recliners with Light, Massage, and Heat Functions
- Q&A: Wiring Diagram for Lippert Stabilization Jack LC298707
- Shop: Brake Controller
- Shop: Replacement Drive Head for Solera Power RV Awnings - Regal Style - Black
- Search Results: roof rack hardware
- Shop: Roadmaster Comfort Ride Shock Absorbers for Triple Axle Trailers - 5,200 to 7,000-lb Axle
- Shop: Roadmaster Comfort Ride Shock Absorbers for Tandem Axle Trailers - 3,500-lb Axle
- Shop: Roadmaster Comfort Ride Add-On Kit for Triple Axle Trailers - 5,200-lb to 7,000-lb Axles
- Shop: Fifth Wheel Hitch
- Q&A: Where to Find Label on Lippert Stablizer Jacks to Identify and Replace Them
- Shop: Replacement Hook Up Brackets for Curt Weight Distribution Systems
- Video: Breaking Down the Replacement Tongue Jack for Lippert Ground Control TT Leveling System
- Video: All About the Replacement 24-1/2" Left Rear Leg
- Q&A: Can Lippert Ground Control 3.0 Rear Jack be Replaced Without Purchasing Motor
- Q&A: Replacement Wiring Harness and Right Rear Jack for Lippert Ground Control 4 Point System
- Q&A: What is Difference Between Lippert # PSX1 and PSX2 Stabilizer Jacks
- Q&A: Replacement Jack For A Lippert Hydraulic Leveling System
- Search Results: stabilizer jack switch
- Video: Lippert Components Trailer Jack LC144214 Review
- Q&A: Wiring Diagram for Lippert Stabilizer Jack # LC298707
- Search Results: rv light switches
- Search Results: blu technology
- Video: Review of the Double Spacer Kit for Lippert Power Stabilizer Jack
- Article: Breakaway Kit Installation for Single and Dual Brake Axle Trailers
- Search Results: 225/70/r15 trailer tires
- Search Results: trailer tires and wheels
- Search Results: free shipping
Richard C.
6/23/2025
The stabilizer system on my 2012 Sunset Trail Reserve trailer is not working properly. The back stabilizers are working fine. The front ones were not working at all, so I replaced the switch and they worked fine on our first two camping trips. When we arrived home the other day, I could not get them to go down. I attempted to hand crank them and they would not budge. I took the motor off and found it was froze because the motor was burnt up. I replaced the motor and now the stabilizers will go up by operating the switch, but not go down by the switch. I have checked all fuses and all are fine. I replaced the switch with a new one. Still the same. Could it possibly be the female plug? I would appreciate your help and advice. Thank you.