Replacement Mounting Bracket And Hardware For A Folding Hand Rail for Brophy RV Scissor Stairs

Question

Question:

Re: AHR4 Brody scissors railing. Can I buy replacement brackets - wing nuts? Regards,

asked by: Kim A

0

Expert Reply:

We carry the trailer wall mounting bracket for the Folding Handrail # AHR4 with part number # 2005. All other hardware (bolts, nuts, knobs, etc.) would have to be either purchased through Brophy or if it's not too damaged you can take it your local hardware store to find replacements for much cheaper than going through a manufacturer and paying for shipping.

expert reply by: Kevin C

0

Answer 1

I spoke with my contact at Brophy and they said the maximum weight capacity of the Brophy Aluminum Scissor Steps, part #AS24, is 300 lbs. If you are needing a hand rail for the aluminum steps I would recommend the Brophy Aluminum Hand Rail for 4 Step…

view full answer...

Answer 2

The height measurement on the item you selected is 24 to 30 inches to the mounting bracket. As long as the distance from the area the stairs are to be mounted straight down to the ground is within this 6 inch range the stairs will work nicely. We…

view full answer...

Answer 3

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 4

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 5

Can you email me the diagram so I can take a look at it?

view full answer...

Answer 6

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Answer 7

Thanks for the picture! I checked with Progressive Dynamics the replacement power converter you need for your Parallax Series 7300 Model 7345 is the Replacement Converter for Parallax/Magnetek or WFCO RV Power Centers - 45 Amp item #PD4645V.

view full answer...

Answer 8

Hello Kirk, thanks for reaching out. Our best option for replacing your Carson power pack converter would be replacing the whole power center with the Progressive Dynamics 4000 Series Mini RV Converter w/ Charge Wizard and AC/DC Distribution Panel…

view full answer...