Depth and Width Of Tandem Axle Teardrop Trailer Fender HP94VR

Question

Question:

Could you provide the dimensions of the tear? Looking for the depth and width of it at the widest point

asked by: Will

0

Expert Reply:

The Tandem Axle Teardrop Trailer Fender # HP94VR you were looking at is 9" wide the whole length of the fender, and at it's largest is 15" deep/tall.

expert reply by: Samuel C

0

Answer 1

According to Blue Ox, it'll take an experienced installer about 4 to 5 hours to complete the installation of their #BX1128 Base Plate Kit on a 2016 Jeep Grand Cherokee. The install isn't what I'd call super-difficult, but the installation…

view full answer...

Answer 2

Hey Bryan, that's a good question. The pricing can definitely be misleading, but I wouldn't use it to judge the quality of the tire. A lot of that comes down to promotions, inventory, and whether you're looking at a tire by itself or…

view full answer...

Answer 3

Thanks for the pics Kemo, they really helped! The CE Smith Single Axle Trailer Fenders #CE19504-2 are larger than what you currently have and use a different mounting style. Based on your setup, the CE Smith Fenders wouldn’t bolt onto your existing…

view full answer...

Answer 4

Hey Tom! Yes, the Tandem Axle Teardrop Fenders w/ Backing Plates #HP92VR are 72" long. The full dimensions are 72" long x 10-3/4" wide x 20-1/2" tall. What kind of trailer do you have?

view full answer...

Answer 5

Hey Emanual, welcome back! Which Timbren 3,500 lbs system do you have? The standard duty ones like item #ASR3500S05 have a #84 Spindle, so the Timken item #TMK52VR you were looking at would be the correct kit. However, some of the heavy duty Timbren…

view full answer...

Answer 6

Hey Alan, thanks for reaching out! The Tandem Axle Teardrop Trailer Fenders for Enclosed Trailers #HP74VR are really close to the specs you referenced and while they don't have a "standing" weight capacity, if you give them enough…

view full answer...

Answer 7

Hello Bruce, thanks for reaching out. We do have leaf springs for 3,500 lb axle, so we may have something that will work for you. I will need to know the length of your current springs to make sure the new ones will fit into your suspension. For…

view full answer...

Answer 8

The recommended lug nut torque for your 7,000lb axle depends on a few factors like wheel size, stud size etc. Check out the attached photo which shows the torque specs for a variety of applications. I see you were looking at the Dexter Nev-R-Adjust…

view full answer...

Answer 9

The Replacement Wet Shoulder Bolt #LC126238 is exactly what you are looking for. It's the correct length and diameter as well as has the zerk fitting needed to grease it.

view full answer...

Answer 10

I was able to track down a wiring diagram of the Atwood Water Heater Relay 93849 which I have attached for you below.

view full answer...

Depth and Width Of Tandem Axle Teardrop Trailer Fender HP94VR

Product Page this Question was Asked From

Continue Researching