Correct SnapPad for 10-1/2" Replacement Foot Plate for Lippert Power Gear Hydraulic Jack
Updated 05/03/2024 | Published 06/05/2023
Products Featured in This Question
Question:
what is the snap pad for this foot plate Item # LC359344
asked by: Patrick J
0
Expert Reply:
The correct SnapPad kit for your Replacement Foot Plate # LC359344 is the SnapPad Prime Jack Pads # SP84FR4.
If you need just a single SnapPad then you're looking for part # SP84FR instead.
expert reply by:
Jon G
0
Product Page this Question was Asked From
Replacement Foot Plate for Lippert Power Gear Hydraulic Jack
- Accessories and Parts
- Camper Jacks
- Trailer Jack
- Jack Foot
- Lippert
more information >
Continue Researching
- Q&A: How Does The Discontinued Power Gear 500210 Control Panel Make A Complete Circuit?
- Q&A: Which Victron Solar Power Controller to Replace Midnite 150
- Q&A: Which B&W Fifth Wheel to Gooseneck Adapter Is Best For Towing My Trailer?
- Q&A: Lug Nut Torque Chart for Trailer Wheels
- Q&A: Recommended Replacement For A UFP Model A-70 Brake Actuator
- Q&A: Can B and W Companion Hitch Work with Curt Helux Pin Box
- Q&A: Installing Lippert Components Power Gear Manual Leveling Control Kit on Older Power Gear Kit
- Article: Trailer Wiring Diagrams
- Article: 30-Amp and 50-Amp RV Service: What's the Difference?
- Article: Wiring Trailer Lights with a 6-Way Plug (It's Easier Than You Think)
- Article: Best Vehicles to Flat Tow Behind an RV
- Article: Double-Eye Trailer Suspension System Review
- Article: 7 Common Questions Everyone Has About Trailer Tires
- Article: How to Measure for Trailer Hitch Drop
Will
5/2/2024
I only need one snap pad