What Size Mounting Bracket Will the Bulldog Round, Snap-Ring Swivel Jack # BD151110 Fit?
Updated 05/01/2023 | Published 04/28/2023 >
Question:
we have 3 custom made trailers that already have jacks on them, but the jacks are too short to level and stabilize the trailer. the mounting style seems to be the same as the 151110 and we already have the bolt on plate for the trailer. can you tell me if the center mounting hole on this jack is an industry standard? would it be as simple as removing the split ring from the existing jacks, remove the one jack and then install this jack to the same mounting plate. I am adding a photo of the existing jack so you can see what we have and the split ring that Im talking about. thanks,
asked by: Michael H
Expert Reply:
To verify fitment of the Bulldog Round, Snap-Ring Swivel Jack # BD151110 on your trailer you will need to measure the diameter of the Bracket # F500242 on your trailer. The diameter of the outer part of the bracket needs to be 2-1/2" for the Bulldog jack to fit. It is held in place with the Snap-Ring # BD500241 if any of your snap rings are going to need to be replaced.
Continue Researching
- Shop: Trailer Hitch
- Shop: Curt Trailer Hitch Receiver - Custom Fit - Class III - 2"
- Search Results: top wind jack handle
- Search Results: trailer jack handle
- Search Results: trailer brakes
- Search Results: b10ea 22
- Search Results: gs1719dl
- Shop: etrailer Electric Trailer Brakes - Self-Adjusting - 10" - Left/Right Hand Assemblies - 3.5K
- Shop: Grease Seal - Double Lip - I.D. 1.719" / O.D. 2.565" for 3.5K Axles with #84 Spindles
- Shop: Replacement Topwind Knob Handle for Ram Jacks
- Search Results: 010~009~00
- Shop: Grease Seal - Double Lip - I.D. 1.500" / O.D. 1.987" - 2,000-lb to 2,500-lb Axles - Qty 1
- Search Results: hopkins 20400
- Shop: Dutton-Lainson Pull Pin Swivel Trailer Jack w/ Foot - Sidewind - 15" Lift - 2,000 lbs
- Shop: Curt Round, Snap-Ring Swivel Jack - Weld On - Topwind - 15" Lift - 2,000 lbs
- Q&A: Replacement Mount to Install Fulton Trailer Jack # TJ120W0301 on Opposite Side of Trailer
- Q&A: Retaining Ring Diameter for Bulldog Swivel Jack
- Video: All About the Replacement Retaining Ring for etrailer and Ram Snap Ring Swivel Jacks
- Article: Trailer Wiring Diagrams
- Q&A: What is the Difference Between a Class II and a Class III Hitch?
- Shop: Trailer Wiring
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Q&A: Lug Nut Torque Chart for Trailer Wheels
- Video: Curt T-Connector Vehicle Wiring Harness Review C56040
- Q&A: What is the Difference Between a 4-Way and 7-Way Trailer Connector
- Article: How to Measure for Trailer Hitch Drop
- Shop: Suspension Enhancement
- Shop: Brake Controller
- Q&A: Comparing Kenda KR03, KR35, And KR53 Tires
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
