Recommended RV Roof Vent To Replace Older Maxxair 8900K

Question

Question:

We need to Replace our 8900k Exhaust Fan roof top unit

asked by: Jeff S

0

Expert Reply:

To replace your older Maxxair 8900k I recommend going with the MaxxFan Deluxe Roof Vent # MA00-07500K.

This vent will fit the same cutout in your roof, and the remote will allow you to adjust between the 10 speeds, set the thermostat, and open the vent lid.

You'll also need the install kit # 344270KITW to keep your vent from leaking.

expert reply by: Samuel C

0

Answer 1

Hey Mike! The Soft Start Kit for Coleman-Mach RV Air Conditioners #CM56RR is designed to work with 45000, 47000, and 48000 air conditioners. Based on those numbers I'm assuming you those are 38000 series, but the model number doesn't always…

view full answer...

Answer 2

Hey Darin, this is a great question but since you have the Lippert Tire Linc Prep Kit that means you have everything but the sensors that mount on the valve stems and the repeater. So for that you'd just need the part #LC37VR which is a pair of…

view full answer...

Answer 3

It is not an exact science that must be followed, so no worries. The amount of overhang can vary to a degree and still be just fine. Sometimes there will be an obstacle in play that determines limitations as well, adjoining slides so limited mounting…

view full answer...

Answer 4

I would be happy to clarify for you. Yes, the Furrion Chill Replacement RV Air Conditioner for Coleman Setup item #FR42PV has soft start built in. The start capacitor stores energy that will later be used for the next startup. This offers an extra…

view full answer...

Answer 5

Hey Bill, great question! The Signature Mach 15 is your standard AC unit which is probably what you want. The Roughneck has a fortified interior making it ideal for off-road and heavy industrial vehicle applications. Basically it is made to take more…

view full answer...

Answer 6

Hello Michael, thanks for reaching out. Yep, you sure can. For replacement brackets and pins for your MaxxAir vent cover you can use the following: - Replacement Hardware Kit for MaxxAir FanMate RV Roof Vent Cover #MA94GR This comes with 4 brackets,…

view full answer...

Answer 7

Both the smoke and white colors will be the same in regards to how much heat gets through and will be relatively similar when it comes to light, although the smoke will naturally be a little darker. Since you'll be using the roof vent AND a cover…

view full answer...

Answer 8

Thanks for the info. I'm happy to assist with the correct fits which are based on flange to flange measurements of your slides and will be purposefully wider than your slide for the hardware. For your 12 foot slide use #LCV000163298 (slide out…

view full answer...

Answer 9

You can use the RV Propane Gas Detector #RS64FR (white) or #RS44FR (black) to replace your current Atwood 31013 propane gas detector. This will also use a 12v, 2-wire installation like your current detector.

view full answer...

Answer 10

Hey Andrew! Yes, Furrion does have a Chill Cube model with a heat pump. This was actually just released for aftermarket sale. You will need a complete system to make the switch, new R32 units aren't backwards compatible with old R410A systems.…

view full answer...

Answer 11

Hey Jon; I was actually just talking to Furrion about heat options for the Chill Cube yesterday (1/21/2025). At this time, the only way to have heat with this unit is through a furnace on a ducted setup. The Furrion Chill Cube RV AC w/ Air…

view full answer...

Answer 12

Congrats on the new motorhome Edward! SnapPad doesn't have the 2026 Allego Red 38 KA in their system so I don't know what size your jack feet are. However, we have a few options that will work with the HWH leveling systems. What you'll…

view full answer...

Recommended RV Roof Vent To Replace Older Maxxair 8900K

Products Featured in This Question

Product Page this Question was Asked From

Featured Help Information

Instructions

Miscellaneous Media

Continue Researching