Options For Rebuilding Obsolete Shorelandr SS370 Hub with 3/4" and 1-1/4" Bearings
Updated 04/18/2023 | Published 04/16/2023 >
Products Featured in This Question
Question:
I need a boat trailer hub that uses bearings with an ID of 3/4 and 1.25. Shorelandr discontinued their SS370 hub. The wheel pattern is 5 x 4-1/2. Can you help?
asked by: Robert D
Expert Reply:
I have a solution to rebuild your hub as long as it's just the bearings/races that are worn, but that bearing combination is obsolete so there's no new hubs available.
Since it's very uncommon that the physical hub itself gets damaged you should be able to rebuild it. Based on your measurement's you'll need the following parts:
Races # LM11910 and # LM67010
Bearings # LM11949 and # LM67048
You'll also need some grease of which I really like the Hi-Temp Grease # L11380.
Product Page this Question was Asked From
Replacement Race LM11910 for Bearing LM11949 - Qty 1
- Trailer Bearings Races Seals Caps
- Races
- Standard Races
- 1.78 Inch O.D.
- Bearing LM11949
- Race LM11910
- 3000 lbs Axle
- etrailer
more information >
Continue Researching
- Q&A: Availability of 72 inch Long Tandem Axle Trailer Fender in Diamond Plate
- Q&A: Adapter and Re-Wiring Kit for Lance Truck Camper with Round Pin 7-Way Plug
- Q&A: How to Replace a Lance 6-Pin Plug w/ a Standard 7-Way Connector
- Q&A: How Long Does It Take to Install B&W Turnoverball Underbed Gooseneck Trailer Hitch BWGNRK1020
- Q&A: Can I Replace a UFP A-70 Surge Brake Actuator w/ the Replacement Inner Member for Dexter DX7.5L?
- Article: Parts Needed to Add Electric Drum Brakes to a Trailer
- Q&A: Options for Adding Electric Brakes to Trailer Axle without Brake Mounting Flanges
- Q&A: Recommended MORryde X-Factor Crossmember Installation Locations on Tandem Axle Trailer
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Trailer Lighting Requirements
- Article: 5 Things to Know About Weight Distribution Hitches
- Article: How to Bleed Your Trailer Surge Brakes
- Article: Double-Eye Trailer Suspension System Review
- Article: Wiring Trailer Lights with a 4-Way Plug (It's Easier Than You Think)

