Troubleshooting A Furrion Vision S RV Camera System That Fades In And Out Of Pairing
Updated 03/09/2025 | Published 03/24/2023
Products Featured in This Question
Question:
I have a furrion S backup camera and had to hard wire in our new 2023 Outback. Camera is paired and comes on however it’s on and off and states no single. Blue lite is on the camera. Do I need a booster? The camper is approximately 38 long travel trailer Since the camera has a blue light I assume it’s getting power or do I need to pull the wiring back out and re wire. I hope it’s not that cause pulling out all the wire out is a pain to get in and out.
asked by: Mike W
Expert Reply:
Furrion Vision S RV Camera Systems like the # FOS43TASF have a 492' range so the length of your trailer isn't to blame here. Most likely the unit is getting enough power to turn on and sometimes pair and then loses the signal as the voltage drops. The solution to this is to pull the camera back off of the trailer and splice in the PWM Wiring Adapter # VGR64VR behind it so that it gets a steady 12 volts in order to properly operate.
I've attached a video below where I'll walk you through installing this adapter. Getting the adapter back in the hole can be a bit challenging depending on its size, so if needed you can enlarge the hole a bit since it's going to be covered by the camera gasket. If you want to go the extra mile you can also cover the hole a bit once you're done with some gasket maker to ensure a waterproof seal.
Featured Help Information
Miscellaneous Media
Continue Researching
- Shop: 12V PWM Filter for RV Backup Camera Systems - Hardwire
- Shop: 7-Way Vehicle Power Adapter for Furrion RV Observation Camera
- Video: Setting up the 12V PWM Filter for RV Backup Camera Systems on a 2021 Thor Coleman Motorhome
- Video: How to Set Up Your 12V PWM Filter for RV Backup Camera Systems on a 2020 Taxa Mantis Travel Trailer
- Shop: RV Camera
- Search Results: pwm filter
- Search Results: air bag compressor kit
- Q&A: Should Air Lift WirelessONE Compressor Kick On When Truck Is Sitting With Everything Off?
- Search Results: rhino sewer hose
- Search Results: furrion rear camera
- Search Results: equalizer hitch parts
- Shop: Furrion Vision S+ Wireless RV Backup System w/ 1 Camera - 7" Screen
- Video: In-Depth Review of the 7-Way Vehicle Power Adapter for Furrion RV Observation Camera
- Shop: Kenda Karrier KR53 ST205/75R14 Radial Trailer Tire w/ 14" Black Spoke Wheel - 5 on 4-1/2
- Q&A: Does Furrion Vision S+ Have to Use Included Power Cable for Monitor
- Shop: Trailer Wiring
- Search Results: furrion 7"
- Search Results: rv plug adapters
- Shop: Fifth Wheel Hitch
- Q&A: No Signal And PWM Fix For Furrion Vision S Camera System Connected To 2022 GMC
- Shop: MORryde I-Beam Mounted Stabilizer for 5th Wheels and Travel Trailers
- Shop: Voyager PWM Filter for Voyager RV Camera Systems - CEC Connector
- Q&A: Troubleshooting A Furrion RV Camera System That Won't Stay Connected To The Monitor
- Video: Trailer Valet XL Trailer Dolly with Chain Drive Comprehensive Review
- Shop: Curt 5th Wheel/Gooseneck Custom Wiring Harness w/ 7-Pole Connector and Cover Plate - 7' Long
- Q&A: Is there a Way to Use Aftermarket Monitor With Furrion RV Observation Cameras
- Article: 2 Steps for Finding the Right Weight Distribution Hitch Size
- Q&A: No Signal on Furrion Vision S Wireless RV Backup Camera System
- Video: Review of Equal-i-zer Weight Distribution Hitch Head - EQ90-02-1000
- Q&A: Why Does Furrion Vision S Camera Kit Require Adapter for Newer Chevy Truck
on RV Camera System
Aaron
3/9/2025
Hi Kevin, I’m not sure the filter is my error. When the camper is not moving, the signal is fine and clear. Once I get over about 40mph is when my drops out. Any thoughts? Thanks, Aaron