Should a 6-Point or 12-Point 7/16" Socket Be Used On Stromberg Carlson Electric Tongue Jack?

Question

Question:

Is the 7/16 socket for a Stromburg Carlson electric jack manual crank a 6 point or 12 point

asked by: Terry

1

Helpful Expert Reply:

It is best to use a 6-point 7/16" socket with the Stromberg Carlson Electric A-Frame Tongue Jack # JET-2500. You are able to use a 12-point as well but the 6-point is less likely to damage or round off the jacks manual crank point. The Handle # SC94VR uses a 6-point for this reason as well.

expert reply by: Bud M

1

Answer 1

That's really good info! Thanks for coming up with that and passing it on. I posted it here so that others in your situation could be helped by it.

view full answer...

Answer 2

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 3

According to Blue Ox, it'll take an experienced installer about 4 to 5 hours to complete the installation of their #BX1128 Base Plate Kit on a 2016 Jeep Grand Cherokee. The install isn't what I'd call super-difficult, but the installation…

view full answer...

Answer 4

Hi Paul, you’re definitely on the right track here, and I can help you narrow this down with confidence. With your tandem 3,500 lb Dexter axles and 33 inch spacing, both the Dexter EZ Flex part #K71-652-00 and the Lippert Road Armor part #LC53CK are…

view full answer...

Answer 5

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Answer 6

The #84 spindle is just a common way to identify the spindle dimensions typically used for 3,500 lb axles. So instead of listing out the parts, people can just say they have #84 spindles and it's easier to know what fits it. The CE Smith Trailer…

view full answer...

Answer 7

That's a very good question, we tend to be extra cautious and say to use 10 gauge wire because that would be more than enough. When you get into longer trailers that will end up using a lot of wire the heavier gauge wire becomes more necessary.…

view full answer...

Answer 8

You can use leaf springs that are rated higher than the axle without any issues as long as they measure the correct measurement for your trailer. For example the 6-leaf double eye spring for 7,000 lb axles part #e64SR measures 24-7/8" eye to…

view full answer...

Answer 9

Congrats on the new motorhome Edward! SnapPad doesn't have the 2026 Allego Red 38 KA in their system so I don't know what size your jack feet are. However, we have a few options that will work with the HWH leveling systems. What you'll…

view full answer...

Should a 6-Point or 12-Point 7/16" Socket Be Used On Stromberg Carlson Electric Tongue Jack?

Products Featured in This Question

Product Page this Question was Asked From

Continue Researching