What is the Depth of Steps on 25 Series Kwikee Electric RV Step Complete Assembly

Question

Question:

i am looking at the Kwikee Electric RV Step Complete Assembly - Triple - 25 Series - 24 Wide Item # LC3658373 does this step have an 8 run? the rise is listed at 8 but no mention of the run also what is the difference between the steps LC3658373 and the steps LC365837 thank you

asked by: Steve A

0

Expert Reply:

Based on your 8" guess I'm assuming you mean the depth of the steps on the # LC3658373. The full dimensions of each step are 24" wide x 11-1/8" deep. This is the complete assembly with all of the wiring and the switch kit.

The Replacement Steps, Motor, and Control # LC365837 is the replacement for the # LC3658373. So, if you are replacing your existing steps then you need the # LC365837. Otherwise you want the complete asssembly # LC3658373.

expert reply by: Robin H

0

Answer 1

The original steps all came with the open switch originally so I would assume that it's the original configuration and that nothing has been previously replaced. If you just want to swap out the magnets, the opposite magnets that are normally…

view full answer...

Answer 2

We carry a few choices the Replacement Door Switch for Lippert Electric Coach Step #LC301694 and the Replacement Magnetic Door Sensor for Kwikee Electric RV Steps #LC369299 that you may need depending on if your circuit needs to be open or closed.…

view full answer...

Answer 3

The Replacement Steps, Motor, and Control for Kwikee RV Electric Steps #LC365837 are the correct replacement steps for your Kwikee 902509100. If you are also wanting a new switch and sensor you will need the Complete Assembly #LC3658373

view full answer...

Answer 4

The correct replacement control model for the SCS/Frigette Coach Step Controller part 202-3230 is the Replacement Control Module for Lippert Electric Coach Step part #LC301702.

view full answer...

Answer 5

I could not confirm the Lippert 32 Series Double Step Frame #LC3722618 (Lippert part 908032000) as the correct item for your application. My contact at Lippert did not recognize the OEM Frigette coach step that came on your Georgetown and he suggests…

view full answer...

Answer 6

The only parts list for your triple step is attached. It unfortunately does not give the breakdown to the extent you are seeking with Teflon plate and wave washer as those parts are not replacement options from the manufacturer. I've attached the…

view full answer...

Answer 7

The problem is you do have the wrong switch for your door sensor. Whenever we hear that the steps are working in reverse that usually means you have the incorrect door switch, normally closed vs normally open or it is installed wrong. For a normally…

view full answer...

Answer 8

Choosing the right height setting for your 5th wheel hitch is a combination of a few different variables. First of all you want your towing setup to be as level as possible. With your Montana High Country 340BH level you will want to measure from the…

view full answer...

Answer 9

From the measurements you've given me you're looking at approximately a 3" difference between the hitch and the pin box king pin plate. To remedy this you can adjust the height of your pin box (if possible) lower to make up the…

view full answer...

What is the Depth of Steps on 25 Series Kwikee Electric RV Step Complete Assembly

Products Featured in This Question

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching