Replacement Winch For Shelby 5438

Question

Question:

Hello, I have a 4 cable Shelby 5438 lift system on my 1991 StarCraft galaxy pop up and need a replacement winch that will hold 4 cable system. Any help appreciated. Mark K.

asked by: Mark K

0

Expert Reply:

For a replacement winch for your Shelby 5438 you can use the Dutton-Lainson Hand Winch # DL14934.

expert reply by: Kyle S

0

Answer 1

I do have a winch replacement option for you, but unfortunately there is no direct replacement for your older Shelby 5438 winch in your pop up camper. I recommend the Dutton-Lainson Hand Winch w/ Automatic Brake - TUFFPLATE Finish - 1,200 lbs…

view full answer...

Answer 2

The Dutton-Lainson Hand Winch w/ Automatic Brake #DL14934 will work as an excellent replacement for your Shelby 5438 lift system with the 4 cables. We've had a number of people who've used this in the exact same situation as you and it's…

view full answer...

Answer 3

It looks like you have one of the 1983-2000 models. There are no replacements for the winch from that setup so the only solution would be to modify a winch like the #SW1130220 to make it work. I'm not sure how long those cables are but based on…

view full answer...

Answer 4

Great question! I believe that you're wanting to extend that handle out horizontally so that you aren't having to 1 - get on your hands and knees while operating the winch, and 2 - having to keep removing and installing the handle because it…

view full answer...

Answer 5

I have attached for you below a dimensional drawing of the Dutton-Lainson Hand Winch with Automatic Brake part #DL14934 which you can then use to determine fit and compatibility. I am not sure how your existing winch is setup but you can use the…

view full answer...

Answer 6

The Dutton-Lainson Hand Winch #DL14934 works as a replacement for the old Shelby 5438 that has been found on other 1998 Starcraft pop ups. If your 1998 Starcraft Ventura 2406 has the same Shelby 5438 than you should not have any issues replacing it…

view full answer...

Answer 7

I do have a solution for you, but it will not include replacing a wheel on your existing winch. Your Shelby Winch, model 5351, is a 1,000 lbs winch with a 2-way ratchet. If you need to replace your existing winch I recommend a winch by Dutton…

view full answer...

Answer 8

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 9

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 10

According to Blue Ox, it'll take an experienced installer about 4 to 5 hours to complete the installation of their #BX1128 Base Plate Kit on a 2016 Jeep Grand Cherokee. The install isn't what I'd call super-difficult, but the installation…

view full answer...

Answer 11

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 12

Hey Andrew! Yes, Furrion does have a Chill Cube model with a heat pump. This was actually just released for aftermarket sale. You will need a complete system to make the switch, new R32 units aren't backwards compatible with old R410A systems.…

view full answer...

Replacement Winch For Shelby 5438

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching