Replacement Snap Pads For Equalizer System w/ Four 10" Octagon Feet and Two 11-1/2" Round Feet

Question

Question:

I have a 2022 keystone fusion 428 with eq jacks 4-10” octagon feet and 2-11 1/2 “ round will this part fit

asked by: Dan T

0

Expert Reply:

While the # SN88FR will not fit the octagonal and round feet from your Equalizer leveling system, we do have exactly what you need:

- SnapPad Grand Lux Jack Pads for Equalizer Leveling System w 10" Octagon and 12" Round Feet # SP74FR84

The # SP74FR84 comes with four pads that fit 10-1/2" octagonal feet and two pads that fit the 11-1/2" round feet of your trailer with the Equalizer leveling system.

expert reply by: Kyle S

0

Answer 1

The Black Prest-O-Fit 4-Piece Step Rug Set #PR83SR is designed to fit the 23-1/2" wide steps on the MORryde Gen II StepAbove RV Steps #MR28RR and #MR85RR. We also have the Rug Set in Brown #PR23SR if you prefer the lighter color.

view full answer...

Answer 2

Hi Paul, you’re definitely on the right track here, and I can help you narrow this down with confidence. With your tandem 3,500 lb Dexter axles and 33 inch spacing, both the Dexter EZ Flex part #K71-652-00 and the Lippert Road Armor part #LC53CK are…

view full answer...

Answer 3

Congrats on the new motorhome Edward! SnapPad doesn't have the 2026 Allego Red 38 KA in their system so I don't know what size your jack feet are. However, we have a few options that will work with the HWH leveling systems. What you'll…

view full answer...

Answer 4

Hey Priscilla, since you have a Dometic water heater that currently has a 16 inch by 16 inch door currently the correct Furrion Tankless Water Heater would be the part #FR32TD that you referenced which comes with this size door. Are you ready for…

view full answer...

Answer 5

Hey Chris, nice Brinkley! The correct B&W 5th Wheel Setup depends on your pin box bolt pattern and the weight of your trailer. For your 2026 Ford F-350 with the 6-3/4' bed and no factory prep package we have the following available: -B&W…

view full answer...

Answer 6

To measure your octagon foot pads, you just need to measure your foot pad from one flat side, straight across to the other flat side. The SnapPad BF 10 Jack Pads #SN26FR you were looking at would work if you get a measurement of 10". There is…

view full answer...

Answer 7

Personally I prefer the SnapPad XTRA Jack Pads #SP54FR4 over the Stromberg Carlson #SC99MR as they have been around much longer and proven themselves to be a quality product. Both these will fit 4 jacks with a 9" round landing pad.

view full answer...

Answer 8

We have the MORryde RV Cargo Sliding Tray - 90" x 33" - 2 Way Slide - 60 Percent Extension - 800 lbs #MR46FR. This will replace your old system no problem. If you have a damaged unit you can contact our customer service department and speak…

view full answer...

Answer 9

Hey Richard. The MORryde GooseTech 5th Wheel to Gooseneck Pin Box like item #MR27MV has not been approved for use by Grand Design. It does not fall under their 5-year limited towable frame warranty that applies to the 2020 and newer 5th wheel…

view full answer...

Answer 10

Hey Joe, great question! I actually talked to one of the B&W reps about this exact thing when they were here a while back. For the B&W Companion 5th Wheel Hitch #BWRVK3300, the best place to start is the middle position (A). That’s the…

view full answer...

Answer 11

As long as all the other voltage and information matches you are able to use the CBB65-R Capacitor #FR65FR in place of your C65-R. These are simply series information numbers which I have found both listed on the exact same capacitor.

view full answer...

Replacement Snap Pads For Equalizer System w/ Four 10" Octagon Feet and Two 11-1/2" Round Feet

Products Featured in This Question

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching