Overall Dimensions of Performance Tool Electric Car Jack

Question

Question:

could you tell me the overall dimensions of the jack itself?

asked by: Leon E

0

Expert Reply:

I have attached a photo below of the Performance Tool Electric Car Jack part # PTW1609 dimensions. The base measures 7" long x 5" wide x 5-14" tall.

expert reply by: Conner L

0

Overall Dimensions of Performance Tool Electric Car Jack
(click to enlarge)

Answer 1

Trailer stabilizer jacks like #TJSCHD-24 are not designed to be used to lift a trailer and hold it up for maintenance. Their purpose is to stabilize the trailer while it's parked and no more. What you're looking for is a jack to hold the…

view full answer...

Answer 2

Hey Mike. I don't have a hydraulic scissor jack, but I do have an electric one. It's the Performance Tool Electric Car Jack item #PTW1609. It has a 2-ton capacity, extends up to 14", and plugs into a cigarette lighter. The Power Mountain…

view full answer...

Answer 3

For attaching to a 2 inch frame you'd be best served welding the Leveling Scissor Jack Set #JSC-30 since there wouldn't be enough width to get several bolts to it.

view full answer...

Answer 4

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 5

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 6

Hey Jeff. There is definitely a correlation between weight and capacity. I've listed the weight of all three of the Power Mountain Tallboy Off-Road Bottle Jacks we have below: Power Mountain Tallboy Off-Road Bottle Jack - 7-15/16" to…

view full answer...

Answer 7

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 8

According to Blue Ox, it'll take an experienced installer about 4 to 5 hours to complete the installation of their #BX1128 Base Plate Kit on a 2016 Jeep Grand Cherokee. The install isn't what I'd call super-difficult, but the installation…

view full answer...

Answer 9

Hi Paul, you’re definitely on the right track here, and I can help you narrow this down with confidence. With your tandem 3,500 lb Dexter axles and 33 inch spacing, both the Dexter EZ Flex part #K71-652-00 and the Lippert Road Armor part #LC53CK are…

view full answer...

Answer 10

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Answer 11

The #84 spindle is just a common way to identify the spindle dimensions typically used for 3,500 lb axles. So instead of listing out the parts, people can just say they have #84 spindles and it's easier to know what fits it. The CE Smith Trailer…

view full answer...

Answer 12

Even though I cannot comment specifically on the grease you used because I am not familiar with it, I can tell you the best grease for trailer bearings is a a grease with a rating of GC-LB, which just means it is made to withstand very high…

view full answer...

Overall Dimensions of Performance Tool Electric Car Jack

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching