Correct Replacement Hardware and Brackets for Westin HDX Grille Guard on 2003 Chevy Silverado 1500

Question

Question:

I hav a 2003 Chevrolet z71 pickup truck and I would like to put on it a HDX Brush Gard and need Brackets to fit will I be able to get them?

asked by: Willie B

0

Expert Reply:

The correct replacement hardware and bracket kit for the Westin HDX Grille Guard with Punch Plate part # 57-1175 which is a fit for a 2003 Chevrolet Silverado 1500 is the Replacement Hardware Kit for Westin HDX Grille Guards part # 57-117PK.

expert reply by: Conner L

0

Answer 1

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 2

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 3

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 4

Congrats on the new motorhome Edward! SnapPad doesn't have the 2026 Allego Red 38 KA in their system so I don't know what size your jack feet are. However, we have a few options that will work with the HWH leveling systems. What you'll…

view full answer...

Answer 5

Yes, it will work. You'll just need to cut the Lance 6-pin connector out and rewire it into the etrailer Trailer Wiring 7-Way Upgrade Kit w/ Junction Box and RV Style Connector item #e99011. Here are the individual functions of that Lance 6-pin:…

view full answer...

Answer 6

That's a very good question, we tend to be extra cautious and say to use 10 gauge wire because that would be more than enough. When you get into longer trailers that will end up using a lot of wire the heavier gauge wire becomes more necessary.…

view full answer...

Answer 7

Hey Tim, I checked out your Predator 5000 generator and it does use a quick connect propane connector like what the part #CAM57629 provides so yes this would work. How do you like the Predator generator?

view full answer...

Answer 8

The brake wire providing voltage is wired in parallel, with one lead from each magnet being grounded to the trailer frame. We have a great Wiring Help Page that shows a diagram, I will provide a link to it below.

view full answer...

Answer 9

The biggest difference will be capacity. The Curt Hitch part #C15302 that you referenced is on the high end of the capacity spectrum. It's a Class V hitch that has the following capacities: Maximum gross trailer weight: 16,000 lbs Maximum GTW…

view full answer...

Answer 10

We do have an option for replacing your Elixir ELX-60. Unfortunately there is not going to be a direct replacement for the converter section. You will need to replace the entire panel with the Progressive Dynamics 4500 Series RV Converter…

view full answer...

Answer 11

Even on manufactured trailers wiring colors can vary so there is no way to say for sure. The only way to know which wire is tied to which function is to trace the wire back. On an SAE standard 7-way the brown wire would be the tail/running lights. On…

view full answer...

Answer 12

Hey Justin, the cab style actually doesn't factor with hitches like the Curt part #13322 so yes it will fit all cab styles of the 2012 Chevy Silverado 1500. This is full list of trucks this hitch fits: 1999 - 2013 GMC Sierra 1500 1999 - 2004 GMC…

view full answer...

Correct Replacement Hardware and Brackets for Westin HDX Grille Guard on 2003 Chevy Silverado 1500

Products Featured in This Question

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching