Replacement Master Cylinder For A 2016 Demco AT6000P Car Hauler  

Yes, there are replacement master cylinders for surge brake actuators like the Demco Actuator part #DM8203102 that you referenced. If this was the actuator that you have you would want the Replacement Master Cylinder #5672. If you have a different…

The manual lockout on your Atwood 85778 surge brake coupler is there so that you can back up the trailer without the brakes locking up on you. Yes you can safely tow your trailer with the broken manual lockout, you just have to make sure you…

You can convert surge brakes to an electric over hydraulic braking system. To do this, you will need an electric over hydraulic actuator and a brake controller. For an electric over hydraulic actuator, I recommend looking at the Carlisle HydraStar…

The attachment bolts for a 5-bolt brake assembly like the part #AKEBRK-6R should be torqued to 30-50 foot/lbs. If you don't have a torque wrench handy, if you tighten the bolts until the lock washers flatten out, you'll be pretty darn close…

According to Dexter, the nut should be torqued to between 45-70 foot lbs. If you don't have a torque wrench close at hand, Tighten the bolts until the lock washer flattens, which will put you really close to the correct torque. We offer 4 nuts…

The front equalizer of the part #K71-656-00 is different because it does not attach to shackles on the one side. The higher side attaches directly to the leaf spring without a shackle. Dexter determined that this provided the smoothest ride quality…

First you will need to remove the old hydraulic equipment. Remove the surge coupler or actuator, remove all the lines, and finally remove the brake assemblies. If you have 10 inch diameter hub and drums, you may need to replace those as well. If you…

Hi Charles, While we don't currently offer the inner member that you're needing for the UFP A-70 we do offer a compatible replacement with the Dexter DX7.5L A-60 Brake Actuator #DX33FR. This is the entire actuator assembly along with the…

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

I'm assuming you have hydraulic drum brakes and actually need the brake actuator. If that is the case, you're looking at either extending the tongue so you can bolt on an actuator like the #DX33FR or welding one on like the #DEX94FR. Both…