Amber and Red LED Trailer Clearance and Marker Lights With Clear Lens

Question

Question:

Hello, looking to get the equivalent light to a MC48AB, but with a clear housing.

asked by: Adam W

0

Expert Reply:

The closest lights to the size of the Optronics Trailer Clearance or Side Marker Light w/ Reflector # MC48AB with are clear lens are going to be the Miro-Flex LED Clearance or Side Maker Light. This is available in Amber # MCL17CAB and Red # MCL17CRB based on the positioning of the lights on your trailer.

expert reply by: Bud M

0

Answer 1

The Miro-Flex part #MCL63AB and the Thin Line part #MCL75AB are both very similar. They essentially are just visual differences for the lens. The Miro Flex has more of a Euro style look where you can see the diodes and the reflective base in the…

view full answer...

Answer 2

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 3

Hey Andrew! Yes, Furrion does have a Chill Cube model with a heat pump. This was actually just released for aftermarket sale. You will need a complete system to make the switch, new R32 units aren't backwards compatible with old R410A systems.…

view full answer...

Answer 4

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Answer 5

The #84 spindle is just a common way to identify the spindle dimensions typically used for 3,500 lb axles. So instead of listing out the parts, people can just say they have #84 spindles and it's easier to know what fits it. The CE Smith Trailer…

view full answer...

Answer 6

That's a very good question, we tend to be extra cautious and say to use 10 gauge wire because that would be more than enough. When you get into longer trailers that will end up using a lot of wire the heavier gauge wire becomes more necessary.…

view full answer...

Answer 7

A trailer that is over 80 inches wide is required by DOT regulations to have rear clearance lights. An over 80 inch taillight kit, like part #TL16RK, will have the side clearance light built into it. An under 80 inch taillight does not have the…

view full answer...

Amber and Red LED Trailer Clearance and Marker Lights With Clear Lens

Products Featured in This Question

Continue Researching