Ramp Spring Recommendation for 2022 Thor Toy Hauler

Question

Question:

I have 2022 Thor Toy Hauler. What size system do I need to help lift the door?

asked by: Linda T

0

Expert Reply:

Are you wanting to do a torsion style spring that fits above the door like most toy haulers? Do you know how wide the door is and about how heavy the door is? Typically an 8 foot wide ramp spring like the part # M354FR is what you'd want as this matches the width of standard toy hauler doors and has a 120 lb lifting capacity.

expert reply by: Jameson C

0

Answer 1

The 120-LB #M354FR is going to likely be a better option with the door weight between 125-130lbs. While the 150-LB #362SA8207 will work the higher weight will make the door want to raise up off the ground which can be troublesome when trying to load…

view full answer...

Answer 2

I don't know how wide your rear door is but we have an 8 foot wide rear door we have the 120 lb kit part #M354FR or for a 7 foot wide option we have the part #ERS120D81. These are for enclosed style trailers. If you have a open trailer with side…

view full answer...

Answer 3

Hey Amy, thanks for reaching out! The Conventional Ramp Door Spring for 8' Wide Enclosed Trailer #M354FR could work out as a replacement spring for your 2001 horse trailer, but we'll need to check the specs with your trailer to see if this…

view full answer...

Answer 4

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 5

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 6

Hey Bryan, that's a good question. The pricing can definitely be misleading, but I wouldn't use it to judge the quality of the tire. A lot of that comes down to promotions, inventory, and whether you're looking at a tire by itself or…

view full answer...

Answer 7

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 8

Hi Paul, you’re definitely on the right track here, and I can help you narrow this down with confidence. With your tandem 3,500 lb Dexter axles and 33 inch spacing, both the Dexter EZ Flex part #K71-652-00 and the Lippert Road Armor part #LC53CK are…

view full answer...

Answer 9

The 5.30-12 tires, being wider, are going to make more contact with the road. This means that the noise, and heat build up will be higher than a 4.80-12 tire but the rolling resistance will actually be less because the tire is larger diameter. The…

view full answer...

Answer 10

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Answer 11

The #84 spindle is just a common way to identify the spindle dimensions typically used for 3,500 lb axles. So instead of listing out the parts, people can just say they have #84 spindles and it's easier to know what fits it. The CE Smith Trailer…

view full answer...

Answer 12

Even though I cannot comment specifically on the grease you used because I am not familiar with it, I can tell you the best grease for trailer bearings is a a grease with a rating of GC-LB, which just means it is made to withstand very high…

view full answer...

Ramp Spring Recommendation for 2022 Thor Toy Hauler

Products Featured in This Question

Continue Researching