Can Control Module on Titan BrakeRite II SD be Replaced

Question

Question:

I need a new control module for a brake rite SD. I see a part number T4834200, but cannot find one. Can you help?

asked by: Kevin A

0

Expert Reply:

The Replacement Remote Mounted SD Control Module for BrakeRite II T4834200 was discontinued a little over a year ago back at the start of 2021. So while it might be the correct replacement for your system, it isn't readily available on the market so you'll either need to see if you can find a used one or you'll need to go with a new electric-over-hydraulic (EOH) system for your trailer.

For your application I recommend swapping over to the Hydrastar Vented Marine Electric Over Hydraulic Actuator for Disc Brakes # HS381-8067. This system just has the single unit so you aren't relying on as many pieces and it has been well accepted by those in the towing world.

Attached is a review video for you to check out.

expert reply by: Jon G

0

Answer 1

I spoke with my contact at Dexter and he said the Dexter Electric Over Hydraulic Brake Actuator #K71-651 is for disc brakes applications. A unit designed for disc brakes does not have a check valve so the drum brakes cannot function properly. For…

view full answer...

Answer 2

If you have a Titan BrakeRite Electric-Hydraulic Actuator for Disc Brakes like part #T4813102 installed there is a way you can troubleshoot the system to make sure it is faulty before replacing it. You would perform a 3 wire test. You will need a 12…

view full answer...

Answer 3

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 4

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 5

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 6

According to Blue Ox, it'll take an experienced installer about 4 to 5 hours to complete the installation of their #BX1128 Base Plate Kit on a 2016 Jeep Grand Cherokee. The install isn't what I'd call super-difficult, but the installation…

view full answer...

Answer 7

Hi Paul, you’re definitely on the right track here, and I can help you narrow this down with confidence. With your tandem 3,500 lb Dexter axles and 33 inch spacing, both the Dexter EZ Flex part #K71-652-00 and the Lippert Road Armor part #LC53CK are…

view full answer...

Answer 8

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Answer 9

The #84 spindle is just a common way to identify the spindle dimensions typically used for 3,500 lb axles. So instead of listing out the parts, people can just say they have #84 spindles and it's easier to know what fits it. The CE Smith Trailer…

view full answer...

Answer 10

Hey Bryan, that's a good question. The pricing can definitely be misleading, but I wouldn't use it to judge the quality of the tire. A lot of that comes down to promotions, inventory, and whether you're looking at a tire by itself or…

view full answer...

Answer 11

The Demco Hydraulic Trailer Brake Actuator part #DM72VR should be a direct replacement for the Atwood 61101 Brake Actuator that you have now. This newest updated it rated at 7K instead of 6K. This is a bolt on option that mounts on 3" centers.…

view full answer...

Answer 12

The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use. The B&W Companion OEM 5th…

view full answer...

Can Control Module on Titan BrakeRite II SD be Replaced

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching