What is Needed to Install Tekonsha Brake Controller in 2004 Toyota Tundra
Updated 03/29/2022 | Published 03/28/2022
Products Featured in This Question
Question:
Hello I’m looking at tekonska or draw draw brake controller, my question is it’s telling me I will been a ETBC7 to install is that true
asked by: Scott
0
Expert Reply:
If your 2004 Toyota Tundra has a 7-way trailer wiring connector at the rear of it then to install a Tekonsha brake controller like the # 90885 would only require the custom install harness # 3040-P. If you do not have a 7-way then yes you would need the # ETBC7 to convert it to a 7-way and wire up the brake controller.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Curt Custom Wiring Adapter for Trailer Brake Controllers - Dual Plug In
- Accessories and Parts
- Trailer Brake Controller
- Wiring Adapter
- Plugs into Brake Controller
- Vehicle Specific
- CURT
more information >
Featured Help Information
Instructions
Continue Researching
- Q&A: Length of Parking Brake Kit Cable
- Q&A: Recommended Hitch for a 2024 Mazda CX-90 PHEV
- Q&A: Brake Controller Kit For a 2007 Toyota Tundra With a Factory Pigtail
- Q&A: Thickness of Rotor Portion of Kodiak 12-Inch Hub-and-Rotor Assembly KHR12D
- Q&A: 2019 Lance 1475 Lift Kit for 2-5/8 inches
- Q&A: Location of Brake Controller Connector on a 2014 Toyota Tundra
- Q&A: Ground Wire Location on Trailer For Pollak 6-Pole Connector
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Best Bike Racks for Electric Bikes
- Article: How to Measure Your Trailer Wheel Bolt Pattern
- Article: Trailer Lighting Requirements
- Article: How to Raise Your Travel Trailer Height
- Article: Brake Controller Installation on a Ford Full-Size Van
- Article: Brake Controller Installation on a Full-Size Ford Truck or SUV