Installation Manual For Fastway E2 Weight Distribution Hitch

Question

Question:

I have bought a used travel trailer that has a E2 92-00-0800 that has a 800 # tongue weight and 8000# max trailer weight. Do you have setup instruction? I have a F150 2019.

asked by: Ken

0

Expert Reply:

Yes, I have the installation manual for the Fastway e2 Weight Distribution w/ 2-Point Sway Control - Trunnion - 8,000 lbs GTW, 800 lbs TW, part # FA92-00-0800. I will include it with a weblink to our Weight Distribution Hitch Help and Video page below.

expert reply by: Mark Smith

0

Answer 1

Your weight distribution system uses a Shank #FA92-02-4100 that gives you a maximum 6-1/4" of rise and 2-1/4" of drop. I recommend using the Fastway Shank #FA92-02-4214. This will give you up to 10" of rise and 7-1/4" of drop with…

view full answer...

Answer 2

When connecting two batteries together on an RV trailer you usually connect the batteries in parallel to draw 12 volts from both of the batteries. We have a photo, see photo at right, that shows how to wire the batteries in parallel. Once you have…

view full answer...

Answer 3

Hey David. For your 2012 Lance 1685 Travel Trailer, I recommend the Fastway e2 Weight Distribution w/ 2-Point Sway Control item #FA92-00-0800. Your Lance 1685 tops out at 5,400 lbs so this should put your tongue weight around 540 lbs - 810 lbs…

view full answer...

Answer 4

Hello again Frank; tongue weight is typically 10-15% of your trailer weight. At 5,400 lbs you could go over the max 800 lb tongue weight of the #FA94-00-0800 but that probably isn't the case here. If you really want to be sure you could always…

view full answer...

Answer 5

Hey Andrew, the Fastway e2 system part #FA92-00-0800 would be a great option for a weight distribution system and sway control for your 2022 Forest River Cherokee Alpha that has a 720 lb tongue weight. Have you used WD systems before?

view full answer...

Answer 6

Hi Mark! I looked up the specs for a 2025 Airstream Trade Winds 23FBQ and the fully loaded maximum tongue weight it will have is 600 pounds. We have some good options for that weight capacity, like the Fastway e2 Weight Distribution w/ 2-Point Sway…

view full answer...

Answer 7

All of the Replacement Round Spring Bars for the Fastway e2 Weight Distribution systems, #FA94-02-1099, #FA94-02-0899, and #FA94-02-0699, measure 31-1/2 inches long. The diameter of the bar at the upper end is 1.39 inches, and the inside groove…

view full answer...

Answer 8

The correct replacement hardware kit for your Fastway e2 4.5k system is the Replacement Hardware Kit for Fastway e2 Weight Distribution Head #FA92-02-9600. The Replacement Bolts for Equal-i-zer Weight Distribution Head #EQ90-02-9400 you asked about…

view full answer...

Answer 9

Yes, you can get a replacement shank only for a Fastway e2 weight distribution hitch, and there are different options depending on how much rise or drop you need. - Max 7-3/4" Rise, 3-1/4" Drop: Fastway e2 Weight Distribution Shank…

view full answer...

Answer 10

The Curt Trailer Hitch Receiver #C15324 is the highest rated compatible hitch for your 2004 GMC Yukon. All other compatible hitches are class 3's whereas this is a class 5. The Fastway e2 Weight Distribution w/ 2-Point Sway Control #FA94-00-1033…

view full answer...

Installation Manual For Fastway E2 Weight Distribution Hitch

Product Page this Question was Asked From

Featured Help Information

Instructions

Miscellaneous Media

Continue Researching