Solution for Securing 7-Way Wiring to Trailer Frame

Question

Question:

I am looking for something that will attach to the frame of my trailer, near the hitch, that will elevate the 7-pin cord so it does not get pinched on tight turns. Do you have anything like that?

asked by: Matt B

0

Expert Reply:

In order to secure the cord from your 7-way to the trailer frame I recommend using the Steel Tubing Clamp - 3/4" Diameter - Qty 1 # SWC9024-1. This will be able to secure the wire and also allow the cable to still move and not bind when turning.

expert reply by: Robin H

0

Answer 1

Hello Bruce, Thanks for writing in! Using butyl tape between the trailer body and the Single Axle Jeep Style Trailer Fender - Diamond Plate Aluminum - 13" to 15" #HP96VR is exactly the route I would go. It stays flexible, creates an…

view full answer...

Answer 2

Good question, Dave. The easiest way is to match the RVpaws kit to your jack leg or leveling system. For example, there are specific kits for the brands and lineups out there: Standard 2" round jack leg = #RV57FR Standard 2" square jack leg…

view full answer...

Answer 3

Hey Arkadius, welcome back! Yes, the ducted version of the Chill Cube comes with a remote. However, you're going to need the complete system for a replacement. You can choose from the following based on color: -Furrion Chill Cube RV Air…

view full answer...

Answer 4

The parts you listed will need to be compatible with what is on your M101A3 military trailer, rather than the trailer itself. For example, the Master Cylinder #10614 and Replacement Shock Absorber #1844-2 are for Toledo brake actuators; if that is…

view full answer...

Answer 5

Hello John; with that part number it sounds like you have the Coleman-Mach 7330-714. The correct replacement shroud would be the #MA00-325001. Take a look at the measurements in the diagrams below and compare that to what you have now to see if it…

view full answer...

Answer 6

Hi Tom, I completely understand why you’re frustrated, especially after going through two units and even upgrading to the 18,000 BTU model. One thing I wanted to share that sometimes gets overlooked with the Chill Cube ducted setups is the air…

view full answer...

Answer 7

If you were hoping for easy installs on your 2021 Honda Pilot, you are definitely in luck! To start with, the Tekonsha T-One Vehicle Wiring Harness #118291 is a plug and play option that will be a very easy way to get a 7 Way plug, which is needed…

view full answer...

Answer 8

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 9

Hey Tony. The Dexter Dual Hydraulic Jack System w/ Double Acting Pump item #DX42CR does not have a self leveling function. It's either up or down. The pivoting foot pads on the bottom of the jacks are what this system relies on when you're…

view full answer...

Answer 10

I need a little more info from you. Basically we know you have a 5,200 to 7,000 lb rated axle but the additional info we need is the bolt pattern that the wheels you have use as well as the diameter of the spindle where the seal rides. With that info…

view full answer...

Solution for Securing 7-Way Wiring to Trailer Frame

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching