Replacement Heating Element for Dometic GC6AA-10E RV Water Heater

Question

Question:

I have a dometic 6 gallon water heater model # GC6AA-10E. Would the #CAM02143 fit to replace it?

asked by: Brock T

0

Expert Reply:

The proper replacement heating element for your Dometic GC6AA-10E is the Camco # CAM02103. Because the element is accessed from the rear of the unit, Dometic recommends having a qualified service center complete the installation. A specific socket is needed to complete the installation. We offer it as part # CAM09883.

expert reply by: Mike L

0

Answer 1

The correct replacement water heater element for your model GC6AA-10E Atwood water heater is #AT92249. The element is going to be on the back of your heater. I've attached a diagram to assist because the element is located under a cover. There…

view full answer...

Answer 2

I was looking through the manual for the Suburban SW6DE water heaters and found that the Suburban replacement is similar but shorter than the Camco model #CAM02143. It looks like the original one used in that water heater was discontinued and…

view full answer...

Answer 3

I added a photo which shows the location of the heating element of the Atwood Water Heater GC6AA-10E for you. It is item number 17 in the diagram. Atwood does recommend having a professional do the job if you are replacing it due to its location.

view full answer...

Answer 4

Rob, the opening of the TowSmart Threaded Quick Links for Safety Chains #348749M is 5/16" wide.

view full answer...

Answer 5

On your model Atwood Water Heater GC6AA-10E the electric heating element is located in the water tank in the back side of the water heater. Atwood does recommend having a RV repair shop replace the heating element because of it's location.

view full answer...

Answer 6

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 7

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 8

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 9

Hey Andrew! Yes, Furrion does have a Chill Cube model with a heat pump. This was actually just released for aftermarket sale. You will need a complete system to make the switch, new R32 units aren't backwards compatible with old R410A systems.…

view full answer...

Answer 10

According to Blue Ox, it'll take an experienced installer about 4 to 5 hours to complete the installation of their #BX1128 Base Plate Kit on a 2016 Jeep Grand Cherokee. The install isn't what I'd call super-difficult, but the installation…

view full answer...

Answer 11

Hey Jeff. There is definitely a correlation between weight and capacity. I've listed the weight of all three of the Power Mountain Tallboy Off-Road Bottle Jacks we have below: Power Mountain Tallboy Off-Road Bottle Jack - 7-15/16" to…

view full answer...

Answer 12

Hey Jon; I was actually just talking to Furrion about heat options for the Chill Cube yesterday (1/21/2025). At this time, the only way to have heat with this unit is through a furnace on a ducted setup. The Furrion Chill Cube RV AC w/ Air…

view full answer...

Replacement Heating Element for Dometic GC6AA-10E RV Water Heater

Products Featured in This Question

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching