Thank you! Your comment has been submitted successfully. You should be able to view your question/comment here within a few days.
Error submitting comment. Please try again momentarily.
This wrench lets you remove and replace screw-in water heater elements with ease. The zinc-plated wrench works with your screwdriver to reach where other wrenches can't. Fits all 5" regular screw-in elements and 1-1/2" nuts.
Features:
Videos are provided as a guide only. Refer to manufacturer installation instructions and specs for complete information.
Before replacing your element, be sure to use the same wattage, voltage and clamp 00:00:08 style as on element being replaced. Refer to your water heater's owner's manual for safety warnings and installation instructions before starting. For installation, you will need a Philips head screwdriver and a screw and element wrench. Shut off electric power to water heater. Shut off cold water supply to water heater and open a hot water faucet. Open drain valve on water heater and drain the water to a point below elements being replaced. Remove access cover and fold back installation. Remove plastic terminal protector.
Disconnect electric wires from element. Remove element using screw and element wrench. Clean gasket area and treads if needed. Install gasket on element, install element, tighten with wrench. Turn on full water supply. Allow all trapped air to escape from hot water faucet till water has a constant flow.
Close hot water faucet. Inspect wiring; if loose or corroded, repair wiring or consult an electrician. Connect electric wires to element, tighten screws. Replace plastic terminal protector. Replace installation and access cover, and turn on electric power to water heater. Water heater element replacement done.
.
Customer Satisfaction Score:
97% were satisfied with this product
3% of customers were not satisfied
Ratings & Reviews

Robert
4/21/2022
It worked grea, Ive only used it the one time

Charlie C.
4/16/2020
Just fine. Its .... a wrench.

Janet L.
11/14/2022
Cleans tank ok-for cleaning sensors must be installed on side that hits the sensors on the sides.

Scott M.
5/6/2021
Great ,, correct size works perfectly
Do you have a question about this Accessories and Part?
Info for this part was:
At etrailer we provide the best information available about the products we sell. We take the quality of our information seriously so that you can get the right part the first time. Let us know if anything is missing or if you have any questions.



Kevin B.
5/19/2020
Worked just fine and expect it to continue to do the job.