Is There a Replacement 48" Cable for LaSalle Bristol Waste Valve

Question

Question:

Looking for a bristol 48 cable CABLE ONLY.

asked by: Brent S

0

Expert Reply:

I checked with LaSalle Bristol and they don't offer just the replacement cable. If the cable is broke you will need to replace the entire waste valve for which we offer part # 34466N4AB48GMA for black water or part # 34466N11AB48GMA for gray water. If you don't want to mess with fitting new pipes you can just un-bolt the valve from the flange and slide the new one in once the old is out.

expert reply by: Conner L

0

Answer 1

Hey Ken, the LaSalle Bristol Cable-Actuated RV Waste Valve for Black Water Tank #34466N4AB48GMA that you referenced is exactly what you are looking for. It is the same thing as the part number 72-4396 66N4AB48GMA you are looking for we just have…

view full answer...

Answer 2

There unfortunately isn't a guide that tells us the length of the cables that were used in your Winnebago so you would have to trace the cables to determine the correct length needed. From Valterra we only have the 72" length, which you were…

view full answer...

Answer 3

Since the placement of the blank waste valve handle makes it hard to operate I recommend switching out the valve with a cable actuated valve that will allow you to place the handle exactly where you need it. The LaSalle Bristol Cable-Actuated RV…

view full answer...

Answer 4

I contacted Jayco on what flush valves and cable lengths you have on your 2019 Jayco North Point Fifth Wheel. Your black water valve cable is 60" cable which we only offer in a 72". LaSalle Bristol Cable-Actuated RV Waste Valve - Black…

view full answer...

Answer 5

The gasket is the portion of the gate valve that's allowing waste water to leak through and not actually the gate. Both companies are using a rubber gasket that will eventually fail so it really comes down to the other features of the gate valve…

view full answer...

Answer 6

Remove the locknut from the cable housing assembly of the #34466N11AB96GMA. Feed the cable through the mounting bracket or hold in the wall of chassis. Feed the locknut back over the cable and fasten securely to the backside of the bracket or wall.…

view full answer...

Answer 7

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 8

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 9

Hey Andrew! Yes, Furrion does have a Chill Cube model with a heat pump. This was actually just released for aftermarket sale. You will need a complete system to make the switch, new R32 units aren't backwards compatible with old R410A systems.…

view full answer...

Answer 10

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 11

According to Blue Ox, it'll take an experienced installer about 4 to 5 hours to complete the installation of their #BX1128 Base Plate Kit on a 2016 Jeep Grand Cherokee. The install isn't what I'd call super-difficult, but the installation…

view full answer...

Answer 12

Hi Paul, you’re definitely on the right track here, and I can help you narrow this down with confidence. With your tandem 3,500 lb Dexter axles and 33 inch spacing, both the Dexter EZ Flex part #K71-652-00 and the Lippert Road Armor part #LC53CK are…

view full answer...

Is There a Replacement 48" Cable for LaSalle Bristol Waste Valve

Products Featured in This Question

Product Page this Question was Asked From

Continue Researching