Replacing Valve Cable on LaSalle Bristol RV Waste Valve # 34466N11AB96GMA

Updated 05/05/2025 | Published 03/02/2019

Products Featured in This Question

LaSalle Bristol Cable-Actuated RV Waste Valve for Gray Water Tank - Spigot to Hub - 96" Cable

(689)

$102.34

Valterra Cable with Valve Handle - 72"

(32)

$38.62

Question:

how do I replace the cable

asked by: Larry

Expert Reply:

Remove the locknut from the cable housing assembly of the # 34466N11AB96GMA. Feed the cable through the mounting bracket or hold in the wall of chassis. Feed the locknut back over the cable and fasten securely to the backside of the bracket or wall. With the red tab in place, insert the cable housing into the collar entry hole and the wire into the coupler. Tighten allen set screw in the coupler and collar screws in the collar. Secure the cable every 18" to 24" using a zip tie or paperclip. Open the valve, remove the red tab, and close the valve completely.

A diagram is included with the instructions that has an inside view of the housing and everything labeled.

For a new cable we have the part # TC72PB.

expert reply by: Jameson C

Rick B.

5/4/2025

Does anyone have instructions or info on how the cable is attached to a LaSalle Bristol sewer dump valve? Mine is not opening and either the cable is broken or disconnected.

Jameson C.

5/5/2025

@RickB Above in the initial answer is our current best set of instructions for the cable replacement. I wish we had a video or a set of instructions with pictures but at this time that's not something we have.