Replacement Mounting Hardware for CIPA CM11551 Custom Slide On Towing Mirrors

Question

Question:

I am looking for replacement hardware for CIPA mirror part 11551LH, specifically the wedge for the left hand mirror. I found similar looking parts on your website but not with that part #. Can you help me?

asked by: KEN F

0

Expert Reply:

We do indeed offer replacement mounting hardware for the Cipa # CM11551 towing mirror. The wedges aren't available as an individual item, but we offer the complete kit that includes 2 wedges, 2 knobs and 2 felt strips as part # CM11553.

expert reply by: Mike L

0

Answer 1

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 2

Hey Andrew! Yes, Furrion does have a Chill Cube model with a heat pump. This was actually just released for aftermarket sale. You will need a complete system to make the switch, new R32 units aren't backwards compatible with old R410A systems.…

view full answer...

Answer 3

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Answer 4

The #84 spindle is just a common way to identify the spindle dimensions typically used for 3,500 lb axles. So instead of listing out the parts, people can just say they have #84 spindles and it's easier to know what fits it. The CE Smith Trailer…

view full answer...

Answer 5

That's a very good question, we tend to be extra cautious and say to use 10 gauge wire because that would be more than enough. When you get into longer trailers that will end up using a lot of wire the heavier gauge wire becomes more necessary.…

view full answer...

Answer 6

Sure, I can help with that. I can see why the fitment notes are confusing. For a 2012 Toyota Tundra with the factory tow package and factory 7 way connector, you'll want a brake controller that plugs into the factory brake controller port under…

view full answer...

Answer 7

Hello John, thanks for reaching out. Yes, the mounting holes on the TecNiq Contoured Seven Function Box Style Tail Light #TN42XR (driver side) and #TN62XR (passenger side) are exactly the same as the Wesbar 271595 tail light. They are 2" apart…

view full answer...

Answer 8

Hello Alfredo, thanks for reaching out. You are on the right track with the 25-1/4" long 4,000 lb leaf spring part #e57SR. That sounds like exactly what you need size and capacity-wise. I wouldn't worry about any excessive bounce with those.…

view full answer...

Answer 9

Hello Jared, Thanks for writing in! Yes, we have custom brake controller wiring harnesses for your 2014 Toyota Tundra. If you're looking to add a brake controller, I would recommend the Redarc Tow-Pro Liberty Brake Controller with Custom Harness…

view full answer...

Answer 10

Hey Steve! I just heard back from Dexter and you have a 3,500 lb axle. For self-adjusting brakes you can use the etrailer Electric Trailer Brakes #AKEBRK-35-SA. If you prefer Dexter brakes then you need the Nev-R-Adjust #23-468-469. For bearings and…

view full answer...

Replacement Mounting Hardware for CIPA CM11551 Custom Slide On Towing Mirrors

Products Featured in This Question

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching