Does the Center Hole On the Tandem-Axle Trailer Equalizer Kit for 2" Slipper Springs Need a Bushing
Published 09/13/2021
Question:
Can you confirm that the 7/8 inch center hole does not need a bushing on the 13-4 swan shaped equalizer? Thanks
asked by: Darren C
0
Expert Reply:
The Tandem-Axle Trailer Equalizer Kit for 2" Slipper Springs part # AP202 uses a 7/8" diameter wet bolt to secure the equalizer to the hanger. It does not require a bushing.
expert reply by:
Conner L
0
Product Page this Question was Asked From
Tandem-Axle Trailer Equalizer Kit for 2" Slipper Springs - 10-1/8" Long Equalizers
- Trailer Suspension Parts
- Standard Equalizer
- Boat Trailer
- Camper
- Car Hauler
- Snowmobile Trailer
- Utility Trailer
- Slipper Springs - 2 Inch
- 9-5/8 Inch Long
- Tandem Axle
- Dexter
more information >
Continue Researching
- Q&A: Best Replacement for a Wesbar Tail Light 271594
- Q&A: Replacement Grease Seal for Trailer Hub that is Marked 171255
- Q&A: Replacement Bearings and Equalizers for a 2024 East to West 5th Wheel Trailer
- Q&A: Do Slipper Springs Use Bushings on Both Ends?
- Q&A: Are Components of Slipper Spring Equalizer Kits AP302 and AP202 the Same
- Q&A: Replacement Bushing For Dexter 5-Leaf 10,000 Pound Axle Slipper Spring DX45QR
- Q&A: Disc Brake Conversion Kit For 2021 Grand Design Solitude 310GKR With 7,000 lb Axles
- Article: Trailer Wiring Diagrams
- Article: Most Popular Wheel Bearings
- Article: How to Tell the Weight Rating of a Trailer Axle
- Article: Trailer Drum Brakes vs. Disc Brakes: Making the Decision
- Article: Performance Chips and Modules
- Article: Is It Illegal to Leave My Hitch on My Truck?
- Article: Slipper Spring Trailer Suspension System Review