Trailer Hitch Receiver That Is Confirmed To Fit a 2008 Audi A4 With Dual Exhaust

Question

Question:

2008 Audi A4 2.0t Quattro S line, with dual exhaust. Will this fit? It says that it wont fit with dual exhaust, however it seems to take the place of the existing bumper bar with the exception of the center down hitch receiver. I cant see how that would interfere with anything, but would appreciate your confirmation.

asked by: J V

0

Expert Reply:

We do have a receiver that will fit your 2008 Audi A4 2.0T Quattro with the dual exhaust, as the EcoHitch Hidden Trailer Hitch Receiver # 306-X7389 has been confirmed by EcoHitch not to work with the dual exhaust.

The Curt Trailer Hitch Receiver # 11164 is currently the only receiver currently available that will fit your Audi. I have linked an installation video done below on a older A4 that has the dual exhaust like yours.

expert reply by: Bud M

0

Answer 1

Yes, the trailer hitch that fits your 2008 Audi A4 Quattro sedan is the Curt Class-I #11164. The maximum tongue weight is 200 pounds. Note, that all non-trailer loads such as bike racks, cargo carriers and more must be supported by stabilizing straps…

view full answer...

Answer 2

Although the exterior body components of the 2005.5 and later model years of the Audi A4 Avant may be similar, or even the same, the frame structures are not. If you compare the mounting flanges for these two hitches, parts #11164 and #C11180, you…

view full answer...

Answer 3

The Curt Trailer Hitch Receiver part #11164 which is a fit for a 2008 Audi A4 does not require trimming. However, the fit around the lower part of the bumper fascia where it meets the frame brackets for the hitch can be tight and in some cases…

view full answer...

Answer 4

The EcoHitch Hidden Trailer Hitch Receiver #306-X7389 is only a fit for the Sedan model of the 2010 Audi A4. Since you have an Avant Wagon you need the Curt Trailer Hitch Receiver #C11195 instead as this is the only trailer hitch that is confirmed to…

view full answer...

Answer 5

There is a trailer hitch receiver option for your 2002 Audi A4 wagon, but only a 1-1/4, Class I hitch, as there were no 2 inch hitches ever made to fit this vehicle. So while you can add a hitch, it does have to be the 1-1/4 inch, Class I hitch from…

view full answer...

Answer 6

Your 2008 Audi A4 sedan has a Class I hitch receiver available in the Curt #11164. For a Class I hitch, we have 3 adapters available, but you will want to make sure you stay within the capacity of your hitch receiver and using an adapter like this…

view full answer...

Answer 7

We have confirmed with EcoHitch that the hitch part #306-X7389 fits your 2011 Audi A4 Sedan. We had the chance to install the hitch on a similar A4 sedan and we found that it fit and worked well. Check out the install picture I attached.

view full answer...

Answer 8

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 9

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 10

Hey Jonathon thank you so much for all of that additional information! To haul your bikes behind your class C Sprinter motorhome, while flat towing your Mini, I recommend the Hollywood Racks RV Rider Bike Rack item #HLY64FR and the Roadmaster Dual…

view full answer...

Trailer Hitch Receiver That Is Confirmed To Fit a 2008 Audi A4 With Dual Exhaust

Products Featured in This Question

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching