Replacement Door Switch For Lippert Electric Steps

Question

Question:

Does this work with my step, treadlite power step?

asked by: Steve C

1

Helpful Expert Reply:

We carry a few choices the Replacement Door Switch for Lippert Electric Coach Step # LC301694 and the Replacement Magnetic Door Sensor for Kwikee Electric RV Steps # LC369299 that you may need depending on if your circuit needs to be open or closed. # LC301694 is an open circuit that completes when the door is closed, while # LC369299 is a complete circuit that opens when opened, tells the steps to retract. Depending on what your sensor looks like will dictate which one you need.

expert reply by: Bryce D

1

Answer 1

Is it possible the module number is 164889? That cross referenced with our part #LC301702 but the 164989 that you referenced does not match anything I can find.

view full answer...

Answer 2

It sounds like the brake solenoid on your Lippert Electric Tread Lite Step part #LC353542 is not functioning properly. There is a manual lever on the motor that can sometimes get flipped off which will then not allow the steps to stay extended. In…

view full answer...

Answer 3

In order to choose the correct replacement magnetic door switch for a set of Kwikee steps you'll need to know what controller you have as well as the shape and color of the existing door switch. I have attached a few photos which go into detail…

view full answer...

Answer 4

The Replacement Control Module for Lippert Electric Coach Step #LC301702 is the brain for your coach step with serial number 06190. We also have the following parts for your coach step: Replacement Motor for Lippert Electric Coach Step #LC301695…

view full answer...

Answer 5

To begin you will want to begin testing the different circuits of the Step Control Module #LC334850. The brown wire goes to the door switch to tell the steps when to open and close. The yellow wire runs to an ignition switch so that the steps know to…

view full answer...

Answer 6

The original steps all came with the open switch originally so I would assume that it's the original configuration and that nothing has been previously replaced. If you just want to swap out the magnets, the opposite magnets that are normally…

view full answer...

Answer 7

Hey Wendell, It sounds like you could have an issue with either the control module, or the motor of those steps. I would lean more towards the control module since that is what the system runs through. It is most likely sending incorrect signals…

view full answer...

Answer 8

If you check out the diagram I attached you will see how the steps should get wired up. What I would first do is verify that you have voltage in all of the right places on your steps to determine if the module needs to be replaced with the #LC301702.…

view full answer...

Answer 9

The step motor 59734-20 will need to be replaced with the Replacement Motor for Lippert Electric Coach Step part #LC301695.

view full answer...

Answer 10

We're familiar with this issue which happens when the incorrect switch is used. Kwikee Steps use two different magnetic switches. One is a normally open circuit and the other is normally closed circuit. The switch must match the controller.…

view full answer...

Answer 11

Bruce, this is fairly common, and the issue is usually with motorhomes that are wired to work with a normally open circuit and the steps being meant for a closed circuit. To fix the issue, you'll just need to use the Replacement Door Switch for…

view full answer...

Answer 12

I spoke with Lippert and the 158367 didn't come back to anything but 168367 did come up with a 29" Coach Step model. With Coach Step being phased out and replaced with the Kwikee line you'll need the Replacement Steps, Motor, and Control…

view full answer...

Replacement Door Switch For Lippert Electric Steps

Products Featured in This Question

Product Page this Question was Asked From

Continue Researching