What Hardware Is Needed To Install As Drop-In

Question

Question:

How would the sink be attached to the counter top if used as a in?

asked by: Christopher H

0

Expert Reply:

The Better Bath Single Bowl RV Kitchen Sink, # LC421572 can definitely be used as a drop-in mount. It is 25" long x 15" wide with tapered flanges that support the stainless steel sink upgrade being used as a drop in mount, installed using the same type of sink mounting clip hardware as a residential sink. The hardware will need to be sourced locally with specific type used dependent on thickness of your counter-top.

expert reply by: Michael R

0

LC421572_001
(click to enlarge)

Answer 1

Hey Andrew! Your trailer is not too light for the Comfort Ride suspension system. The Roadmaster Comfort Ride Leaf Spring Suspension Kit w/ Shock Absorbers #RM82MR is appropriately rated for the 3,500 lb axles you're upgrading to. This is…

view full answer...

Answer 2

Hey Jonathan! The Dometic B57915.711C0 you have now is an old R410A unit. The Advent Air #ADV84QR is an R32 unit which means you will need a complete replacement with an air distribution box (ADB) and thermostat. Everything switched to R32 in 2025…

view full answer...

Answer 3

Thanks for your question, Bryan! Sometimes it can be hard to get an exact measurement on the leaf springs. I'm not sure if you jacked up the trailer to let the axle hang when you took your measurement, that would be the ideal method, but it's…

view full answer...

Answer 4

Hey Vernon, so I like the SRE4000 kit part #MR67ZR over the CRE3000 as it has better cushioning with more travel. The 3000 has 3 inch of travel whereas the 4000 has 4 so it's going to give you a nicer ride quality.

view full answer...

Answer 5

Yes, the Roadmaster Comfort Ride Shock Absorbers part #RM-2460 will fit your trailer with 5,200 lb axles and a 33" wheelbase. The 5,200 lbs axles you have should be 3" diameter which is why this kit will work for you. I was able to speak…

view full answer...

Answer 6

Hey Tony! Since you have tandem 3,500 lb axles with a 2-3/8" diameter the Roadmaster Comfort Ride Leaf Spring Suspension Kit w/ Shock Absorbers #RM82MR is the correct kit. The different part numbers are based on axle diameter and this one is…

view full answer...

Answer 7

Hey John, To replace the 14,500 BTU Furrion air conditioning unit on your camper, you will need a unit and an air distribution box, and if your air distribution box is not manually controlled (i.e. you have high ceilings), you will also need a…

view full answer...

Answer 8

Hey Tyler, thanks for reaching out! Grand Design actually does have some help in that department, since they have a whole "replacement parts" section on their website. To upgrade the equalizers on your 2020 Grand Design Imagine 21BHE you…

view full answer...

Answer 9

While there is a Comfort Ride shock absorber kit that does fit your 2021 Grand Design Imagine XLS 21BHE, there is not a leaf spring suspension kit, as those are only fits for axles larger than the 3,500 lb tandem axles on your travel trailer. You…

view full answer...

Answer 10

Hey David, If your axles are 2-3/8" in diameter then you could just use the Roadmaster Comfort Ride Leaf Spring Suspension Kit w/ Shock Absorbers #RM82MR instead. Swapping out to heavier axles would likely give you uneven tire wear and…

view full answer...

Answer 11

The shocks on the Roadmaster Comfort Ride Leaf Spring Suspension Kit #RM82MR tend to be superior to the SumoSprings Trailer Helper Springs #TSS-107-40 when you consider the contact area. The SumoSprings will only work as the material comes into…

view full answer...

Answer 12

Hello William, thanks for reaching out. The Roadmaster Comfort Ride Leaf Spring Suspension Kit #RM82MR is for 2-3/8" diameter axles which is the standard 3,500 lb axle size. So this would absolutely work with a tandem 3,500 lb axle trailer as…

view full answer...

What Hardware Is Needed To Install As Drop-In

Product Page this Question was Asked From

Continue Researching