Transmission Cooler Ratings For a 2008 Honda Ridgeline

Question

Question:

So what class is the cooler?

asked by: Dennis K

0

Expert Reply:

The Flex-a-lite Transmission Cooler # FLX400008 does not have a class rating. It is a smaller cooler at only 11" wide x 3-5/32" tall x 3/4" deep.

The larger Derale Series 7000 Tube-Fin Cooler # D13311 is 13-1/2" wide x 5-1/8" tall x 3/4" deep. This cooler has a class I rating with your 2008 Honda Ridgeline.

expert reply by: Bud M

0

Answer 1

The smallest utility trailer we offer is the Detail K2 Mighty Multi Utility Trailer part #K2MMT4X6 which is 6' long x 4' wide. It's highway rated for speeds up to 65 mph which is going to be the limit for a lot of trailers this size due…

view full answer...

Answer 2

Derale transmission coolers like Series 7000 Tube-Fin Cooler #D13311 are USA-made. This particular cooler is a Class I-rated unit intended for subcompact cars. We offer similar Derale coolers, again USA-made products, that are designed for your 1994…

view full answer...

Answer 3

You would need the AN fitting adapters part #D98200 for each end of the cooler and then the clamps part #D13008 for securing the hose to the line, and for hose part #D13016. Most likely you will also need the insta-dapt fitting part #D13004 as well.

view full answer...

Answer 4

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 5

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 6

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 7

Hey Andrew! Yes, Furrion does have a Chill Cube model with a heat pump. This was actually just released for aftermarket sale. You will need a complete system to make the switch, new R32 units aren't backwards compatible with old R410A systems.…

view full answer...

Answer 8

According to Blue Ox, it'll take an experienced installer about 4 to 5 hours to complete the installation of their #BX1128 Base Plate Kit on a 2016 Jeep Grand Cherokee. The install isn't what I'd call super-difficult, but the installation…

view full answer...

Answer 9

Hi Paul, you’re definitely on the right track here, and I can help you narrow this down with confidence. With your tandem 3,500 lb Dexter axles and 33 inch spacing, both the Dexter EZ Flex part #K71-652-00 and the Lippert Road Armor part #LC53CK are…

view full answer...

Answer 10

The main difference between the Curt Trailer Hitch Receiver part #C13416 and the EcoHitch Hidden Trailer Hitch Receiver part #EH97FR is that the EcoHitch has a completely hidden cross tube whereas the Curt cross tube will be visible from the rear of…

view full answer...

Answer 11

Hey Ricardo! Yes, the Curt Trailer Hitch Receiver #C82RJ is the hitch Curt is working on for the new 2027 Telluride. This is a pre-order since Curt hasn't finished the design. It does not include wiring. The wiring harness for the 2027 is also up…

view full answer...

Answer 12

Hi David! There are quite a few hitches offered for your 2026 Honda Odyssey, so I definitely understand wanting to know the differences. There are basically three styles available for you and I have them broken out below: Exposed Crosstube: etrailer…

view full answer...

Transmission Cooler Ratings For a 2008 Honda Ridgeline

Products Featured in This Question

Featured Help Information

Miscellaneous Media

Continue Researching