Can an E-Track like EM59150 Install Across More than One Board
Updated 05/19/2021 | Published 05/18/2021
Question:
Utility trailer floor is made up of 2x10.... can I install between two boards or only in one ?
asked by: Bryan
0
Expert Reply:
Yes you could install an e-track like the part # EM59150 between two boards. There's no requirement that an e-track has to install only on a single board. Having them across more than one board would probably spread the weight out better anyway.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Erickson Horizontal E Track - Zinc Plated Steel - 2,000 lbs - 2' Long - Qty 1
- E Track
- E Track Rails
- Horizontal
- 5 Inch Wide
- 2000 lbs
- 2 Feet Long
- Erickson
more information >
Continue Researching
- Article: How to Install E-Track in 3 Easy Steps
- Article: How to Measure Your Trailer Wheel Bolt Pattern
- Q&A: What Screws do You Recommend to Use with the CargoSmart X-Track Cargo Organizer?
- Q&A: What Gauge Metal is the etrailer Horizontal E Track Made of?
- Q&A: Recommended E-Tracks and Straps for Towing a 4,000 lbs Car
- Q&A: Are The Trimax Hidden Padlocks Available Keyed Alike?
- Q&A: What are the Overall Measurements of 4-Slot Horizontal E-Track - Zinc Plated Steel
- Q&A: Is 3/4 Inch Plywood Floor Adequate for D-Ring Tie Down Anchors with Backing Plate for 3,000 lb Car
- Q&A: How Big Is The etrailer Enclosed Trailer Transition Plate # e32JR?
- Article: Rust Prevention
- Article: Trailer Tire Sizing
- Article: Installing an Electric Brake Controller on 2007-2013 GM Full-Size Truck or 2007-Present GM SUV
- Article: 5 Things to Know About Weight Distribution Hitches
- Article: Overview of Lubricating Grease