RV Accordion/Folding Door Carriers

Question

Question:

I will be ordering RV Accordion/Folding Door Carriers - Qty 14 Item # 37281865 but need to know how to attach/secure the carriers to the folding door. Do you have special fasteners for these carriers?

asked by: Ronald A

1

Helpful Expert Reply:

The replacement carriers for the RV Accordion/Folding Door Carriers, # 37281865 can be used to replace broken/damaged carriers by reusing the same hardware for attachment to the door panels. If new hardware is needed it is best to source same or similar locally as that is not something we carry.

expert reply by: Michael R

1

Answer 1

If I'm reading this correctly, you'd like to mount the spare tire carrier into your bumper? If that's what you're looking for, there is not going to be anything available. Every spare tire carrier we carry either gets mounted into a…

view full answer...

Answer 2

According to Blue Ox, it'll take an experienced installer about 4 to 5 hours to complete the installation of their #BX1128 Base Plate Kit on a 2016 Jeep Grand Cherokee. The install isn't what I'd call super-difficult, but the installation…

view full answer...

Answer 3

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 4

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 5

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 6

The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use. The B&W Companion OEM 5th…

view full answer...

Answer 7

Hey Robert, yes the Kodiak disc brake calipers part #KDBC225DAC that you referenced will replace the Tie Down calipers you have now 46304, they can be used as a left or right hand caliper and does come with ceramic brake pads. If you ever needed…

view full answer...

Answer 8

Since wire color codes are NOT universal, we always recommend wiring by function, rather than wire color. If you look at the Trailer Wiring FAQ article I have linked you to, you can see some diagrams showing the proper way to wire a vehicle and…

view full answer...

Answer 9

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

RV Accordion/Folding Door Carriers

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching