How To Install Diodes with Curt 2 to 3 Wire Tail Light Converter
Updated 04/30/2021 | Published 04/28/2021
Products Featured in This Question
Question:
I had the Curt two to three wire converter and two diodes not sure how to hook up the diodes Im also using a Toyota bed as a trailer I have three lights on each side brake lights bottom back up lights middle and turn signals top
asked by: Charles G
Expert Reply:
In regards to the Curt 2 to 3 Wire Tail Light Converter part # C56196, you will need to install diodes part # RM-690 between the trailer tail lights and converter. The "out" side goes to the tail light and the "in" side goes to the converter. There will need to be one diode on each circuit for a total of six.
Product Page this Question was Asked From
Curt 2-to-3 Tail Light Converter for Towed Vehicles w/ Incandescent Tail Lights
- Flat Tow Wiring Harness
- Splices into Vehicle Wiring
- Tail Light Converter
- Universal Fit
- CURT
more information >
Featured Help Information
Instructions
Continue Researching
- Shop: Trailer Hitch
- Shop: Vehicle Tow Bar Wiring
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Trailer Wiring Diagrams
- Q&A: What Drum do I Need to Replace My Lippert Drum with 696690 Stamped on it?
- Q&A: Buzzing Noise from Vehicle to Vehicle Tail Light Converter Part # C56196
- Q&A: Looking for Hitch that Fits 2007 Volvo S80
- Q&A: Is There a Coiled 5-Way to 5-Way Trailer Wiring Adapter
- Q&A: Wiring a Camper Shell Third Brake Light on a 2017 Chevrolet Silverado
- Q&A: Wall Thickness of 3,500, 5,200 and 6,000 lb Trailer Axles
- Q&A: Electric Brake Compatibility on a Boat Trailer
- Article: Is It Illegal to Leave My Hitch on My Truck?
- Article: How to Choose a High-Low Adapter
- Article: Curt Echo Full Review
- Article: How to Measure Your Trailer Wheel Bolt Pattern
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)