Upgrading Power Converter from MagneTek To Lithium Ready Power Dynamics Converter

Question

Question:

I have a MaganaTek 6332 Convertor in my RV. I have switched to a Lithium Battery and think I need to upgrade my power convertor. Is this true and if so is there a convertor that can plug into the old location?

asked by: Mark E

0

Expert Reply:

After looking through the manual I'm not seeing anything for switching to lithium battery for your MagneTek Converter.

I recommend replacing your current converter with the Replacement Converter for Parallax/Magnetek or WFCO RV Power Centers - 35 Amp Item # PD4635V. This converter has a small black piece that can be pulled and moved over one pin to the LI setting to make it lithium ready.

I've attached a pic for you showing the pin that needs to be moved.

expert reply by: Kevin C

0

Lithium Pin
(click to enlarge)

Answer 1

If you are just looking for a new converter, the Replacement Converter for Parallax/Magnetek or WFCO RV Power Centers part #PD4635V will be a direct upgrade for the Magnetek Converter Series 6300 Model 6332 that you have now.

view full answer...

Answer 2

Hey Ron, the Replacement Converter for your Magnetek Converter Series 6300 Model 6332 is going to be the Replacement Converter for Parallax/Magnetek or WFCO RV Power Centers - 35 Amp item #PD4635V. It being rated a couple amps higher will not be an…

view full answer...

Answer 3

If your Parallax 6300 Q-series is no longer charging your batteries you'll need to replace the unit. The Replacement Converter for Parallax/Magnetek or WFCO RV Power Centers - 45 Amp #PD4645V is the correct replacement for you. The Integrated…

view full answer...

Answer 4

Thanks for the pictures! To replace the converter in the Magnetek Series 6300A Model 6336 you will want the Replacement Converter for Parallax/Magnetek or WFCO RV Power Centers - 35 Amp item #PD4635V.

view full answer...

Answer 5

Yes, the Replacement Converter Section #PD4635V will be a direct replacement upgrade for your Magnetek model 6332 that you have.

view full answer...

Answer 6

Yes, the Replacement Section #PD4635V is an upgraded replacement for your MagneTek 6332 power converter. It will fit in place of what you currently have. The 30Amp fuses are in place for reverse polarity. This means if someone accidently hood up the…

view full answer...

Answer 7

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Answer 8

The wires exiting the rear of your controller serve the following functions. The blue wires carries the brake output from the controller, the white wire is the ground, the black wire supplies 12 Volt power, and the red wire is tied into the vehicle…

view full answer...

Answer 9

Yes, the Replacement Converter for Parallax/Magnetek or WFCO RV Power Centers - 55 Amp, #PD4655V is what you are looking for. This upgrades or replaces the converter section for 55-amp Parallax/Magnetek, WFCO, or Parallax RV power centers and works…

view full answer...

Answer 10

Choosing the correct solar panel kit can be a bit overwhelming because there are so many options out there. For your application I would definitely get another battery (Lithium are the best) and then you might want to go with the Elite #34282184 over…

view full answer...

Answer 11

You can upgrade your Magnetek 6332 using the Replacement Section for AC/DC Power Distribution Panel - 35 Amp #PD4635V.

view full answer...

Answer 12

According to the manufactuer, the recommended replacement for your Parallax Series 7300 Model 7346 converter, is the Replacement Converter for Parallax/Magnetek or WFCO RV Power Centers #PD4645V.

view full answer...

Upgrading Power Converter from MagneTek To Lithium Ready Power Dynamics Converter

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching