What Size Fuse For Fogatti Tankless Water Heater

Question

Question:

What size fuse do I need and where can I get one it’s a fogatti tankless rv water heater

asked by: Larry E

0

Expert Reply:

The Owner's Manual states that the Fogatti # LSB64FR power consumption is 20 watts. In a 12V DC system that would be less than 2 amps. Assuming that there is not anything else on that circuit you can put a 5 amp fuse there.

I would get the Performance Tools # PT52FR kit that will have the 5 amps fuses plus spares to put in your trailer tool box. Sooner or later you will need some.

expert reply by: Les D

0

Answer 1

If the ignitor isn't actually lighting up on your Fogatti Tankless Water Heater then either the propane isn't at the correct pressure or the ignitor is bad. I would start by having a technician check the gas pressure to ensure you're…

view full answer...

Answer 2

The wire colors on the Fogatti RV Tankless Waterheater #LSB44FR are black and red, with black being the negative wire to the battery, and red being the positive, though recently we've seen that sometimes it uses black and white with black being…

view full answer...

Answer 3

The Fogatti RV Tankless Water Heater #LSB64FR has a switch located inside the unit to the left of the exhaust vent. If this switch is off the unit will not operate. There's also a fuse right below it that you'll want to check before turning…

view full answer...

Answer 4

To reset your Fogatti RV Tankless Water Heater - Gas - Automatic Pilot - 41,800 Btu - White #LSB64FR you'll simply need to cut the power running to the unit. You can remove the positive power wire at your battery, at the unit, or simply remove…

view full answer...

Answer 5

The E7 code means there is a problem with the combustion process. To reset the Fogatti RV Tankless Water Heater - Gas - Automatic Pilot - 41,800 Btu - White #LSB64FR check that all moisture is normal. Press the on/off switch or power off to restart.…

view full answer...

Answer 6

AC current is about 10 times as much voltage as DC current so the fuse on your Fogatti RV Tankless Water Heater #LSB64FR is blowing to protect the unit. You'll need to cap off the AC wiring you have and run a new line to your DC distribution…

view full answer...

Answer 7

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 8

Hey Doug! The Firestone Ride-Rite Air Helper Springs #F35FV are the right kit for your 2026 Ford F-350 FX4 dually. However, you will need to measure to be sure it fits. The distance from the top of your rear axle to the top of the jounce bump stop…

view full answer...

Answer 9

Since the pin weight of your camper is 2.1k, I recommend going with the LoadLifter 5000 opposed to the 7500. While technically there is not reason you couldn't use the 7500 kit, it really is not necessary for a camper like yours. Generally the…

view full answer...

Answer 10

The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use. The B&W Companion OEM 5th…

view full answer...

Answer 11

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Answer 12

Yes, it will work. You'll just need to cut the Lance 6-pin connector out and rewire it into the etrailer Trailer Wiring 7-Way Upgrade Kit w/ Junction Box and RV Style Connector item #e99011. Here are the individual functions of that Lance 6-pin:…

view full answer...

What Size Fuse For Fogatti Tankless Water Heater

Products Featured in This Question

Continue Researching