Picture of Gorilla-Lift Utility Trailer Tailgate Lift Assist Installed on Bifold Ramp Trailer

Question

Question:

Is there video or some photos showing this. Im thinking I have asked the wrong question though I asked about split gate but what I actually have is a bi-fold rear ramp.. so again, any video or pictures available?? thank

asked by: Roger W

1

Helpful Expert Reply:

We don't have a video of the # GL1 installed on a bi-fold trailer ramp but I did attach a picture we got from a customer who installed it on a bi-fold ramp setup for you to check out as well.

expert reply by: Jameson C

1

Bi Fold Trailer
(click to enlarge)

Clay

4/14/2025

do you have anymore pictures or videos showing the bifold gates w this lift install ??

Jameson C.

4/14/2025

@Clay At this time no we do not.

Jeff

12/29/2025

What is the rod used on the lower half of the gate? The piece the cable is running over?

Jameson C.

12/29/2025

@Jeff The roller? That's so that the cable can feed in and out without damaging itself on lower edge of the assist.

Jack

4/25/2026

@JamesonCwhere can you find this roller?

Jameson C.

4/27/2026

@Jack we have a replacement roller set with part # GMNR925.

Answer 1

Yes, trailer wiring harness #118551 is a fit for your 2009 Ford E350 van. I have linked a video showing installation on a 2008 E350 which will be the same as the installation for your 2009.

view full answer...

Answer 2

Junction boxes are great for keeping things organized and for making changing out trailer side connectors and troubleshooting easier. They are not a necessity so you can keep it if you want, it is entirely up to you. If you want to use the junction…

view full answer...

Answer 3

Hey Dylan, thanks for reaching out. We do carry that 15" aluminum Liger wheel in black. We have them in both a 5-lug and 6-lug. Take a look at the following: - Aluminum Liger Trailer Wheel - 15" x 6" Rim - 6 on 5-1/2 - Glossy Black…

view full answer...

Answer 4

Hey Richard, welcome back. I don't have specific measurements like that but looking at the pictures of a Wolf Creek 910 camper with a Fox landing step installed, I'm thinking the 36" item #TLE1536 is going to be the minimum extension…

view full answer...

Answer 5

Hello Johnny, thanks for reaching out. Sadly, no we are not able to look up trailer parts using a VIN. There just isn't a universal VIN database for trailers like there is for motor vehicles. Typically only the manufacturer of the trailer would…

view full answer...

Answer 6

It definitely is Landon! The Kenda Karrier KR53 ST205/75R15 Radial Trailer Tire item #KE94WV is a load range D tire that will work great on the highway for a long trip. It has a 2,200 lbs capacity per tire and a maximum speed 87 mph. The 15"…

view full answer...

Answer 7

The factory brake controller connector on your 2021 Jeep Grand Cherokee is located under the dash behind the hood latch, as shown in the provided photo. Keep in mind, the connector will only be there if the vehicle has the factory tow package which…

view full answer...

Answer 8

Hey Chris! The black wire on the etrailer Electric Trailer Jack #e23ZV is just a ground wire. Realistically you can ground it however you want but I would say running it to the frame with a self-tapping screw as indicated in the instructions is the…

view full answer...

Answer 9

Hey Scott! The 4-1/2" spacing you’re seeing on the #DM79FR is the standard bolt pattern used on most flat mount couplers. Unfortunately, we do not carry a coupler that matches your 5" horizontal spacing with the mounting holes 2" apart…

view full answer...

Answer 10

The Gorilla Lift part #GL1 that you referenced could be used on a bi-fold style trailer ramp, but you should note that it would not help at all for extending the second folded portion of the ramp. It would with the first portion of the ramp though.

view full answer...

Answer 11

The Gorilla-Lift Tailgate Lift Assist #GL1 could be used on a folding ramp. Yes, it should be attached to the first section of the ramp that is connected to the trailer. You could either fold the ramp and then lift or if your ramp allows you can use…

view full answer...

Answer 12

If you wanted to use the Gorilla-Lift Utility Trailer Tailgate Lift Assist part #GL1 on your utility trailer with tall sides you would need to have a rail that is 12" to 24" from trailer floor. It does not look like there is one from the…

view full answer...

Picture of Gorilla-Lift Utility Trailer Tailgate Lift Assist Installed on Bifold Ramp Trailer

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching