Can Manual Switch Kit for Pace Edwards Tonneau Be Wired To Upfitter Switch on 2019 Ford F-350

Question

Question:

My Ford F 350 has up lifter switches. Can this be wired directly to one of these switches and not have to use the supplied toggle switch?

asked by: Ignacio M

0

Expert Reply:

Your 2019 Ford F-350's Upfitter Switches can be used instead of the toggle switch for the Manual Switch Kit for Pace Edwards Bedlocker or UltraGroove Electric Tonneau Cover # 311-BL-1120.

The Manual Switch Kit # 311-BL-1120 will work with the Bedlocker or UltraGroove electric tonneau covers, and here are the options that fit your 2019 Ford F-350, depending on your bed size.

Pace Edwards UltraGroove Retractable Hard Tonneau Cover - Electric
-6-3/4 Foot Bed: # 311-KEFA18A44

- 8 Foot Bed: # 311-KEFA19A45

Pace Edwards Bedlocker Retractable Hard Tonneau Cover - Electric
-6-3/4 Foot Bed: # 311-M-BLFA18A44

- 8 Foot Bed: # 311-M-BLFA19A45

I have added links below to some video reviews for you to check out as well.

expert reply by: Kyle S

0

George

8/21/2026

what three pin momentary relay would you use for this

Lazer S.

8/25/2026

@George From the options we carry, I would go with one of the two I have listed below: JR Products Single Rocker Switch - On/Off/On - Water Resistant - SPDT - Black # 37213835 JR Products Single Rocker Switch - On/Off/On - SPDT - Black # 37213915 I will admit to not having a whole lot of options for 3 position switches though, so you may try a local hardware store if these aren't to your liking. I did include a link to all the 3 position options we carry as well.

Helpful Links

dept-pg-rv_light_switch-pt-single_switch-pc-on%7coff%7con.aspx

Answer 1

The manual switch for the Pace Edwards Bedlocker Retractable Hard Tonneau Cover #311-BLC95A17 that fits your 2019 Chevy Silverado 2500 short bed is the following: - Manual Switch Kit for Pace Edwards BedLocker or UltraGroove Electric Tonneau Cover…

view full answer...

Answer 2

If your Pace Edwards Bedlocker has the wiring needed for this switch kit then yes the #311-BL-1120 would work for you.

view full answer...

Answer 3

I have a couple options for you as Pace Edwards no longer makes the remote for your BLT 163 retractable tonneau cover. First the Manual Switch Kit #311-BL-1120 can be added allowing you to open and close the tonneau with the power switch. The switch…

view full answer...

Answer 4

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 5

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 6

According to Blue Ox, it'll take an experienced installer about 4 to 5 hours to complete the installation of their #BX1128 Base Plate Kit on a 2016 Jeep Grand Cherokee. The install isn't what I'd call super-difficult, but the installation…

view full answer...

Answer 7

Hey Jonathon thank you so much for all of that additional information! To haul your bikes behind your class C Sprinter motorhome, while flat towing your Mini, I recommend the Hollywood Racks RV Rider Bike Rack item #HLY64FR and the Roadmaster Dual…

view full answer...

Answer 8

Hey Andrew! Yes, Furrion does have a Chill Cube model with a heat pump. This was actually just released for aftermarket sale. You will need a complete system to make the switch, new R32 units aren't backwards compatible with old R410A systems.…

view full answer...

Answer 9

Hey Kelvin, welcome back. To flat tow a 2026 Ford Maverick with your Demco Commander II Tow Bar item #DM9511012, I recommend the following parts: Baseplate Kit - Demco Tabless Base Plate Kit item #DM38CV Wiring Harness - Roadmaster Diode 7-Wire to…

view full answer...

Answer 10

The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use. The B&W Companion OEM 5th…

view full answer...

Answer 11

Since wire color codes are NOT universal, we always recommend wiring by function, rather than wire color. If you look at the Trailer Wiring FAQ article I have linked you to, you can see some diagrams showing the proper way to wire a vehicle and…

view full answer...

Answer 12

Yes, it will work. You'll just need to cut the Lance 6-pin connector out and rewire it into the etrailer Trailer Wiring 7-Way Upgrade Kit w/ Junction Box and RV Style Connector item #e99011. Here are the individual functions of that Lance 6-pin:…

view full answer...

Can Manual Switch Kit for Pace Edwards Tonneau Be Wired To Upfitter Switch on 2019 Ford F-350

Products Featured in This Question

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching