How To Install Ground Wire On Plug-and-Play Wiring Harness For Redarc Tow-Pro On 2021 Toyota Tacoma

Updated 02/17/2021 | Published 02/14/2021

Products Featured in This Question

Redarc Tow-Pro Elite Brake Controller - Dash Knob - Off-Road Mode - Up to 3 Axles - Proportional

(1676)

$290.00

Plug-and-Play Wiring Harness for Redarc Tow-Pro Trailer Brake Controllers

(494)

$27.00

Question:

I have a 2021 Toyota Tacoma and in the process of obtaining the Redarc Tow-Pro Elite trailer brake controller RED44FR. The installation video was quite good, but I got lost on just how the ground was attached as the video didnt show the final detailed view of the ground wire attached. Could you provide me with a clear closeup image of the ground wire assembled? Thank you.

asked by: Sidney M

Expert Reply:

Absolutely!

Once the 10mm bolt was removed from the frame of the 2021 Toyota Tacoma, we put the terminal end of the ground wire of the Plug-and-Play Wiring Harness for Redarc Tow-Pro Trailer Brake Controllers # RED99FR and reinstalled the bolt. You will then plug the # RED99FR into the Redarc Tow-Pro Elite Trailer Brake Controller - 1 to 3 Axles - Proportional # RED44FR to finish the wiring.

At the 4:35 minute mark of the included video you can see the bolt, and I have included a picture showing the bolt with the ground wire installed, though it is kind of hard to see the terminal connector but the wire is pointing up and is secured with a zip tie.

expert reply by: Samuel C