50 Amp Quick Connects Availability

Question

Question:

Hello, I am in search of the product link below. Would you happen to carry this product? 4X 50A 6 8 10-12 AWG Battery Quick Connect/Disconnect Plug Kit Recovery Trailer

asked by: Cal S

0

Expert Reply:

We have quick connects that are rated for 50 amps with the part # SWC60010-1 which I believe you are looking for. These are sold individually.

expert reply by: Jameson C

0

Answer 1

The part #SWC60010-1. These do not have a male and female designation. If you ordered a quantity of two of these they would be able to connect to each other.

view full answer...

Answer 2

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 3

According to Blue Ox, it'll take an experienced installer about 4 to 5 hours to complete the installation of their #BX1128 Base Plate Kit on a 2016 Jeep Grand Cherokee. The install isn't what I'd call super-difficult, but the installation…

view full answer...

Answer 4

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Answer 5

Since wire color codes are NOT universal, we always recommend wiring by function, rather than wire color. If you look at the Trailer Wiring FAQ article I have linked you to, you can see some diagrams showing the proper way to wire a vehicle and…

view full answer...

Answer 6

Yes, it will work. You'll just need to cut the Lance 6-pin connector out and rewire it into the etrailer Trailer Wiring 7-Way Upgrade Kit w/ Junction Box and RV Style Connector item #e99011. Here are the individual functions of that Lance 6-pin:…

view full answer...

Answer 7

That's a very good question, we tend to be extra cautious and say to use 10 gauge wire because that would be more than enough. When you get into longer trailers that will end up using a lot of wire the heavier gauge wire becomes more necessary.…

view full answer...

Answer 8

Hey Don, thanks for the information! That's a significant amount of sag and a pretty heavy trailer, I recommend the Hellwig Pro Series Helper Springs item #HE79FR for the higher 2,500 lbs capacity. I doubt you're driving around with your bed…

view full answer...

Answer 9

Unfortunately you can not Doug. The factory hitch on your 2020 Ford F-150 Lariat is part of the rear step-bumper assembly. It's bolted to your frame and then the step-bumper bolts to the trailer hitch. Removing the factory hitch removes the…

view full answer...

Answer 10

The Curt Front Mount Trailer Hitch Receiver part #C31083 will work just fine on your 2018 Ford F-150 with Eco Boost Engine. I checked with both Curt as well as past customers as well to confirm this for you. I have also attached a photo of what the…

view full answer...

Answer 11

Hey Wayne! The answer to your question is maybe. As you know, the Curt #C14017 is designed for the F-150 without the factory hitch. Typically this is because the factory hitch is integrated with the bumper and removing it to replace it with the…

view full answer...

Answer 12

Hey Mike, I double checked with Curt just now and their front hitch part #C31083 does fit your 2018 Ford F-150 with the 2.7 liter ecoboost! What are you planning on using the hitch for?

view full answer...

50 Amp Quick Connects Availability

Product Page this Question was Asked From

Continue Researching