Can Furrion RV Observation System Camera Be Wired to Battery for Security Camera Setup

Updated 12/11/2020 | Published 12/10/2020

Products Featured in This Question

Furrion Vision S Wireless RV Backup Camera System w/ Night Vision - Rear Mount - 4.3" Screen

(731)

$477.24

Derale Lighted On/Off Switch for Electric Fans

(4)

$7.60

Roadmaster Hy-Power Diode - (Qty 1)

(350)

$19.65

Question:

Id like to wire my cameras to a switch then direct to the trailer batteries. This would allow me to use the monitor as a security system when Im parked. I know I will have to be careful about turning it off so as not to drain the trailer batteries. My 2021 Dutchmen Astoria was pre-wired to run them from the running lights.

asked by: Randy R

Expert Reply:

What you are wanting to do is possible but will require you to be somewhat creative with wiring. Basically you'd need to run the running light circuit of your trailer as well as power from your trailer battery to the in side of a diode like the part # RM-790.

Then run the output side to the camera installed at the rear of the RV.

Last you'd need install a switch on the wire between the trailer battery and the diode with part # D16740 and you'd be set.

expert reply by: Jameson C