Roof Vent Cover To Keep Snow Off Of MaxxAir MaxxFan Deluxe Roof Vent

Question

Question:

Need vent cover for a max air deluxe cannot open vent with Snow load. Do you have a cover?

asked by: Bruce G

1

Helpful Expert Reply:

We do offer a cover that will keep snow from getting on the lid of your MaxxAir MaxxFan Deluxe Roof Vent # MA00-07500K. You will need the MaxxAir FanMate RV and Trailer Roof Vent Cover # MA00-955002.

expert reply by: Samuel C

1

Answer 1

The MaxxAir FanMate vent cover Item #MA00-955001 is going to be just a little taller but the louvred end tapers in and it does not come with the screen which is Item #MA00-955202. 25" long x 18-1/8" wide x 10-1/4" tall. The MaxxAir II…

view full answer...

Answer 2

The MaxxAir FanMate Rain Cover in Black #MA00-955002, smoke #MA00-955003, or white #MA00-955001 are confirmed to fit the rounded factory mounting points like you see on the attached photo. If you have the flat mounting anchor points like in the other…

view full answer...

Answer 3

Hello Ron, thanks for reaching out. The tallest vent cover we offer from MaxxAir is the MaxxAir FanMate RV and Trailer Roof Vent Cover #MA00-955002. This cover is 10-1/4" tall x 26-1/2" long x 18-1/8" wide and is designed to work with…

view full answer...

Answer 4

The MaxxFan Deluxe Roof Vent w/ 12V Fan, Thermostat, and Remote - Powered Lift - 10 Speed - White Item #MA00-07000K has a brush motor. The MaxxFan Roof Vent w/ 12V Fan - Manual Lift - 4 Speed - White #MA00A04301K however does have a brushless motor.…

view full answer...

Answer 5

We certainly do, it's available in black as part #MA00-955002 or smoke as part #MA00-955003. Both are compatible with the #MA00-04500K MaxxFan Plus RV roof vent you'd looked at. You might also be intereste in the #MA00-955202 bug screen to…

view full answer...

Answer 6

The pin in place rain cover you are referring to is the MaxxAir FanMate, and that cover is compatible with MaxxFan Plus fans. So what I recommend for a compatible fan with the best air movement is a 10-speed fan: - MaxxFan Plus Roof Vent w/ 12V Fan,…

view full answer...

Answer 7

The Replacement Rain Shield for MaxxFan Deluxe Roof Vent part #MA05-30520 is what you want to replace the damaged cover you currently have. As for an additional cover to go over it the MaxxAir FanMate RV and Trailer Roof Vent Cover part #MA00-955002…

view full answer...

Answer 8

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 9

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 10

Hey Andrew! Yes, Furrion does have a Chill Cube model with a heat pump. This was actually just released for aftermarket sale. You will need a complete system to make the switch, new R32 units aren't backwards compatible with old R410A systems.…

view full answer...

Answer 11

You can use the RV Propane Gas Detector #RS64FR (white) or #RS44FR (black) to replace your current Atwood 31013 propane gas detector. This will also use a 12v, 2-wire installation like your current detector.

view full answer...

Answer 12

The main difference between the Curt Trailer Hitch Receiver part #C13416 and the EcoHitch Hidden Trailer Hitch Receiver part #EH97FR is that the EcoHitch has a completely hidden cross tube whereas the Curt cross tube will be visible from the rear of…

view full answer...

Roof Vent Cover To Keep Snow Off Of MaxxAir MaxxFan Deluxe Roof Vent

Products Featured in This Question

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching