Adjuster Plugs for 10 Inch Trailer Brakes
Updated 11/11/2020 | Published 11/10/2020 >
Products Featured in This Question
Question:
I was wondering if there was a part number for the plug that covers the adjustment screw on the back of the brake assembly. I bought 2 sets of electric brakes from you and after I installed them. I went for a test drive and afterwards I realized one of the plugs fell off.
asked by: Bob S
0
Expert Reply:
The adjuster plugs you're looking for are part # BP10-220.
These fit the # AKEBRK-35 10 inch brakes you purchased.
expert reply by:
Charles S
0
Product Page this Question was Asked From
Adjuster Plugs for 7", 10", and 12" Brake Assemblies - Qty 4
- Accessories and Parts
- Trailer Brakes
- Electric Drum Brakes
- Hydraulic Drum Brakes
- Adjuster
- Adjuster Plug
- Redline
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Q&A: Replacement 10-36 Dexter Grease Seal for 2022 Grand Design Reflection
- Q&A: Troubleshooting Voltage Drop to Trailer Brake Assemblies
- Article: Testing Trailer Brake Magnets for Proper Function
- Article: Breakaway Kit Installation for Single and Dual Brake Axle Trailers
- Article: Dexter Service Bulletin #014
- Q&A: Availability Of Brakes And Hubs For AL-KO 4,400 lb Axle
- Article: How to Adjust Your Trailer Brakes | The Ultimate Guide
- Q&A: How To Activate Manual Lockout Or Electric Lockout On DA86 Demco When Reversing Trailer In Gravel?
- Q&A: Which Middle Jack is the Correct Replacement for Lippert 3.0 Ground Control 6-Point System?
- Q&A: Do Dexter Brake Assemblies Like # 23-459 Include Adjuster Hole Plugs
- Q&A: Initial Adjustment Of Nev-R-Adjust Electric Brakes
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: Is It Illegal to Leave My Hitch on My Truck?
- Article: How to Measure Your Trailer Wheel Bolt Pattern



